TP-LINKTL-402 RouterIs a four-PortVroYou can connect up to four computers. If you want to connect more computers, you can select eight or sixteen ports or even more interfaces. You can also buy multiple switches. There are several network cables. If the telecom MODE is a China Unicom or China Netcom leased line, no MODE is needed ).
There are many vrouters in TP-Link, but the vro setting method is similar. The following describes the TP-LINKTL-402 router as an example ).
According to the introduction, the computer, Telecom broadband MODE and TP-LINKTL-402 router correctly connected, can form a network. In this case, open the connected computer, right-hand click the desktop's network neighbors → properties.
Right-hand click Local Connection → properties.
Click TCP/IP protocol properties and set the IP address to 192.168.1.250. Ip cidr blocks can be set between 192.168.1.2 and 192.168.1.254. Do not set the same IP address to multiple computers. Otherwise, an IP address conflict may occur. The subnet mask is 255.255.255.0 and the gateway is 192.168.1.1. Click OK. After the DNS vro settings are complete, configure the vro.
Open IE, enter 192.168.1.1/at the URL, and press Enter.
Enter the user name and password as prompted. The default user name and password of the vro are admin. You can also view the vro manual. Enter the user name and password and click Enter to enter the vro configuration page.
Enter the vro settings page, as shown in.
Shows the router setting wizard.
Click Next, as shown in.
Here we select ADSL virtual dial-up, and the virtual dial-up broadband users of China tietong and China Netcom also select it, and then proceed to the next step.
Click Next to complete vro settings. Set the network parameters and WAN port, as shown in.
Now, all vro settings are complete. You only need to restart the vro. Click System Tools to restart the vro.
In this case, the configuration page is closed, and all computers connected to the vro can be connected to the Internet through the port. Because the DHCP service of the vro is automatically enabled, the vrodhcp automatically assigns an IP address to the computer on the port as long as it is connected to the computer, therefore, other computers can directly connect to the vro or vswitch with a network cable without any need to set up.
For the DNS mentioned above, you can enter the DNS provided by the local service provider, which is divided into the preferred DNS and the backup DNS. If you do not know the local DNS, you can set the preferred DNS to 192.168.1.1, that is, the gateway. If you want to set the computer's DNS address, open the network neighbor → properties → local connection → properties → TCP/IP protocol properties, the following figure shows the local telecom DNS address and the DNS address as the gateway address respectively.
The process of setting TP-LINKTL-402 router is introduced to everyone, I believe that the steps of these diagrams can give you a clear understanding of the whole process of router settings.