What about the computer video device being consumed?

Many friends in the use of UC are often encountered UC prompts "video device is occupied" hint, (caused by a lot of reasons, mainly because you use a number of UC client video function caused, in short, or because of your operation caused by)

First you must quit UC, then unplug your camera USB plug from the machine. Plug it in again, start your UC and see if it's already back up?

Several situations and solutions

Situation one: The video has been adjusted well, behind the name also has a video head, and friends in the video when others can see, but every time on the Michael other people do not see the video, no settings do not send video, video equipment is occupied, not open any video window, restart the computer is the same.

Solution: Can you see the local video after you get up? If you cannot see the recommended reset. See video images of other users? Open My Computer on the desktop to see if the video inside is open.

Situation two: sometimes voice video is not open.

Solution: General 2 kinds of cases: Server busy, Win2K the following operating system recording device has been opened.

Situation three: In the chat room to open the video error.

Solution: Unplug the camera and plug the camera back into the chat room to try again (there are successful cases)

The first method does not work, reload the drive to see if it can be solved (someone in the chat room appears the blackboard video, through this method to solve.)

Situation four: about the audio and video is occupied: Please check if you open the other video (or recording) device, turn it off or restart the computer to try, if you can not solve the replacement of a number try or download the UC version, the previous version removed. If you are using a recording device, you cannot enter voice chat;

Situation five: Be affected by the network may fail to open a few more times to try;

Situation Six: Sound card driver may have problems, suggest checking.

Note: When the camera is installed, a program will be loaded into the boot. Sometimes this program will take up tens of millions of times.

Workaround: Remove the program from the startup item.

5. Execute regsvr32%systemroot%system32qasf.dll regsvr32%systemroot%system32wmadmod.dll These two commands at the command line, then restart Mvbox!

　　Specific steps

Step one: Point start-=-Run

Step Two: Enter the Msconfig after the operation of the point to determine

Step three: Locate the boot in the upper right corner and clean the boot entry in the System Configuration Utility

Step four: Set up and restart the computer. After powering up, a window will pop up to save the settings. There's a check in there. Click to save Settings.