What about the lack of virtual memory for your laptop?

What about the lack of virtual memory for your laptop?

A solution to the low virtual memory of a notebook computer:

1. Enable disk write caching

Right-click on My Computer to select Properties-> hardware, open Device Manager to locate the hard drive you are currently using, and right-click to select Properties. On the policy page of the hard disk properties, turn on enable write caching on disk.

This option will activate the hard drive's write cache to increase the drive's read and write speed. Note, however, that when this feature is turned on, a sudden power outage on the computer can result in irreparable data loss. Therefore, it is best to turn this feature on with UPS. Of course, if you usually use the computer do not do any important data processing work, no UPS does not matter, this function will not cause too much damage to the system.

2. Open Ultra MDA

In Device Management Select the basic/Secondary IDE controller in the IDE ATA/ATAPI controller, right-click Select Properties, and open the Advanced Settings page. The most important setup item here is "transfer Mode", which should generally be selected as "DMA (if available)".

3. Configure Recovery options

When a fatal error is encountered during Windows XP run, a snapshot of memory is saved as a file for system debugging purposes, and this file is useless for most ordinary users, but it can affect the performance of virtual memory. So it should be closed.

Right-click on My Computer, select Properties-> Advanced, click the Settings button under Performance, and select the Advanced page in Performance options. There is a "memory usage" option that, if set to system cache, Windows XP uses about 4MB of physical memory as a cache for read and write hard disks, which can greatly increase the speed of data exchange between physical and virtual memory.

By default, this option is turned off, and if your computer has more physical memory, such as 256M or more, you might want to turn this option on. However, if physical memory is more stressful, the default option should be retained.

The solution to the lack of virtual memory of notebook computer two:

The quickest way to do this is to release the memory that is used, to turn off other programs or browsers that are in use, and to use the 360 accelerator ball to clean up the system's memory and garbage, and to turn off unused services.

Improve the virtual memory of the computer, improve the virtual memory can allow more programs in virtual memory to run, to ensure sufficient memory size. To set the virtual memory method, select My Computer, right-click the properties, and click Advanced Settings Performance Options.

Select advanced in Performance options, click Change Virtual memory option, set virtual memory placed hard disk partition, put C disk is the best. Then set the initial value and the maximum value, the initial value can be set to 1.5 times times the physical memory, the maximum can be set to 3 times times the memory.

To add physical memory to the computer, the level of physical memory is not enough to solve the basic memory, you can buy a pair of two g of memory, plugged into the computer's motherboard memory slot can be.