What about Word 2007 cell capacity is low?

In our daily production of Word personal resume table operation, sometimes encountered table cell size is basically fixed, but need to put more content in the cell. If you encounter a font, font size to be fixed, then how to put more text in the cell? The following few small tricks may not allow you to put in a large paragraph of text, in our normal operation of the Word table, sometimes encountered table cell size is basically fixed, but need to put more content in the cell. If you encounter a font, font size to be fixed, then how to put more text in the cell? The following a few small tricks may not allow you to put into a large paragraph of text, but encountered one or two words can not put down and suppress the situation of Hero Han, or to withstand a burst of.

One, reduce the spacing between words

In the case of basic font format determination, narrowing the distance between text is one of the easiest ways to think. The implementation of the method is also quite simple, that is, first select the text to be adjusted, and then click the "Start" tab "Font" tab in the lower right corner of the dialog Box Launcher, open the Font dialog box. Click on the Character Spacing tab, and then click the "Tighten" option in the Spacing Drop-down list, and then set the crunch point value in the "point value" spinner, which normally allows the Arial 5th Word to be set to "1" points.

There is also a way to make the text more "slim" some, slim, then the space naturally appears big. The method is simple. Select the text in the cell, click on the Ribbon "Start" tab "paragraph" feature group "Chinese Layout" button, in the pop-up menu click "Character Scaling", and then select the corresponding proportions in the cascading menu, you can achieve the purpose of the text thin body.

Second, adjust the edge of cell

You may have noticed that there is a certain distance between the text in the cell and the table line. Narrowing this distance may also be a little bit more space for cell elevation. Just position the mouse over the cell you want to adjust, right-click, and click Table Properties in the pop-up menu to open the Table Properties dialog box. Click the Cells tab, and then click the Options button at the bottom right to open the Unit Cell dialog box. In this dialog box, deselect the "Same as whole table" option, and then use the top, bottom, left, right four trimmer boxes below it. It's OK to make the original number smaller.

If we want to do this on our entire balance sheet, then we don't have to do it in one cell. Just position the mouse in any cell in the table, and then click the Cell Margin button in the Alignment feature group, under the Ribbon table tools, to open the Table Options dialog box and adjust the The corresponding value in the default cell margin is OK.

Although there is not much room in this cell, the adjacent cells can be squeezed again. So you'll definitely want to adjust the table line for the cell. However, the adjacent cells do not have much space, and drag the table line with the mouse can not always be dragged to the desired position, very difficult to operate. Don't worry, this is what you should do:

Click on the Ribbon Page Layout tab page Setup feature group in the lower right corner of the dialog Box Launcher, open the Page Setup dialog box, click the Document Grid tab, and then click the Drawing Grid button below to open the Drawing Grid dialog box, and then under Grid settings, the horizontal spacing and Vertical spacing After the number is adjusted to the minimum. This makes it much easier to adjust the form line again.

If you think this method is more verbose, then you can press the "ALT" key, and then drag the table line with the mouse, you can also achieve accurate movement.

Classification:

• Word Tutorial