What if the computer boot line is unplugged?

Many friends in the assembly of computers, often encounter pull down, do not know how to plug back when. In this case, what should be done. Come together to study.

　Tools/raw Materials

Computer

Two-Phillips screwdriver (a small one or a medium choice) silicone

　Method/Step

1, the case opens the lid to be appropriate the screw eye of the motherboard chooses the screw base installation position and installs

2, the installation of power box line hole position is below the Don't get back

3, the CPU to the motherboard on the CPU coated a small amount of silica gel (if the CPU fan has silica gel can not be coated) Install the CPU fan

4, the installation of memory must be inserted in the end to allow the memory of the gold fingers completely inserted into the slot

5, the chassis of the jumper to connect to the motherboard (if you can not see the board's instructions)

6. Install the bezel on the chassis (don't stroke it)

7, the motherboard installed in the chassis, a good screw

8, the installation of the hard disk screws on both sides of the screw screw

9, the Power supply box power cord and hard drive data cable connected to the motherboard power box to the hard disk power supply of the split line do not forget to the hard drive to connect

10, to here basically the assembly is completed if you want to add graphics and optical drive can be completed after these steps to continue the installation

11, in the insertion of small joints, look at the picture below in turn.

　Attention matters

1 Try not to touch the firmware on the motherboard (especially the chip) by hand to prevent electrostatic breakdown

2 When installing the CPU, be sure to be careful with the direction of installation

3 when on the motherboard screws, be careful when the screwdriver does not poke or scrape to the chip on the motherboard

4 motherboard screws do not tighten too tightly

5 The screw base in the chassis (on the motherboard screws) must be all screwed in place

The above is the computer start line has been pulled out of the solution, I hope to be helpful to everyone!