When connecting without a line, the "Getting network address" is displayed, but the others are connected! What's going on here?
Today, we share the solution with the small knitting.
One: Check whether to start the DHCP service
Open the Start menu in the lower left corner of the desktop, find the Control Panel option in the list, and click Open.
Go to Control Panel, view change to "small icon" and then find "admin tools" in the list below click Open
Enter the Admin tool and click on the "service" option in the list to enter the system service interface
In the list of services, locate the DHCP client service, click Change the startup mode to Automatic, and then click the startup option below.
Two: Incorrect IP address settings cause
Right-click on the desktop "Network" option, select Properties, access to the Network properties interface, click on the top left corner of the menu bar "Change adapter Settings"
Then in the network list, locate the local connection, right-click on the attribute, go to the local Connection property interface, and click Open Internet Protocol.
Then fill in our LAN shared network IP address, as well as DNS address, complete the completion of the problem solved.
Three: Access authentication type error; Click the Start menu--> Select Connect to (T)--> Click Show All Links (S)--> right click on "Local Area Connection"--> Select "Properties"--> switch to the Authentication tab in the Local Area Connection properties -> check "Enable IEEE 802.1X authentication for this network"--> and then set the EAP type to smart card or other certificate--> click "OK"-Restart the computer, and if you still prompt "Getting network address", see step Fourth;
Four: Virus trojan, malicious plug-in infection, download and install 360 security guards or Jinshan poison PA and other anti-virus software, to 360 security guards as an example--> open 360 security Guardian window--> Click "Functional Encyclopedia"--> Click "Repair Network (LSP)" In Network optimization--> In the lower right corner of the pop-up window click Repair now--> Restart the computer as prompted, still unresolved? Please see step fifth;
Five: The network card driver exception causes a display "is getting network address", Baidu Search "Drive Wizard"--> download Installation Driver Wizard--> Open the Driver Wizard program, click "Driver"--> find "network adapter"--> click "Download"--> After downloading, click Install--> reinstall NIC driver, restart the computer;
Six: Finally, if after four steps above, "The problem of getting network address is still not resolved, this should focus on the router itself, the small is recommended that you first restore the router's factory settings, and then check the network cable between the devices connected to each other, most likely the cause of the hardware is" getting network address " The fault.