What if the MacBook is flooded?

What if the Macbook is flooded? According to Apple's warranty, malfunction caused by the water after the equipment is not covered by the warranty service, if you want to repair the need to pay high maintenance costs. So, do you choose to pay for maintenance or buy a device again? There is a bit of hands-on ability of the Netizen gave his own answer, that is, DIY to assemble a MacBook, by replacing the faulty parts to let the MacBook rejuvenated, the following people follow the small series together to see the "Great God" The assembled MacBook Graphic Raiders!

First of all, we need to do the following preparatory work:

-Individual hardware configurations including motherboards, I/O boards, network cards, and SSD SSDs

-Fan, fan foot pad, stereo, data cable pair, and microphone cable

-A shell for the screen, a B case with the above configuration, and a case for the bottom cover C, it is important to note that the best choice is the B-shell type with the keyboard, and no more time to screw the 50 screws on the keyboard.

Second, the official installation of the following begins:

1. Because the B-shell is equipped with a keyboard, we need to install the trackpad and battery, we must tighten the left and right 6 screws and 1 large screws below.

2. Put the screen on the A shell, the most convenient way is to rely on the corner of the table, the screen after the screw tightening. By the way, the microphone cable adhesive, the right side of the three fixed large screws and a small screw tightening, with iron plate to secure the card slot.

3. The screw on the left side also carries out the same operation, pay attention to the right side of the large screw, and then to the WiFi, Bluetooth and FaceTime line fixed in the left two screw holes, the picture of the screw does not tighten the iron sheet.

4. Connect the motherboard's power supply module as shown in the figure.

5. Connect the HMDI cable.

6. Next, we need to install the audio and secure the power to the board.

7. Install the entire board onto the B-shell.

8. This is the second-to-last step, and we can work with the annotations in the diagram. After the completion of the wiring work, the entire MacBook Pro assembly is basically completed 80%, followed by SSD installation, the following figure, on the network card connected to 3 lines, in the Geosyncline to install the FaceTime line.

9. Install the system, boot, done, the following image on the left is the new MacBook Pro after the assembly.