Problem 1: hardware problems or electronic components problems
1. If the boot screen does not light up, press the power button and there is no response, teach everyone to release static electricity: Unplug the battery, press and hold the power key for 5 seconds, repeat three times, re-connect the power supply and battery, start a boot attempt ;(
Press and hold the open key.)
2. If you still cannot start the instance, check whether there is a battery low-voltage icon on the screen. If yes, you need to enable the instance quickly and wait until the instance is fully powered. The following figure shows the low-voltage icon:
3. If the charger is properly connected, the instance can be started. If the charger is unplugged, the instance cannot be started, or the cell phone automatically shuts down, you need to replace the battery;
Problem 2: I can solve system or software problems through flash.
1. An HTC G10 has been S-OFF, while ensuring that the phone 60% power remaining, Judge S-off method, the phone shut down the status of holding down the volume does not let go while holding down the key to enter hboot mode.
There are a lot of tips. If you really don't want to enter the hboot mode, you can download a flash brush tool online, sweet pepper brush assistant. There is a "utility" in it that can directly enter the hboot mode, which is simple and convenient.
The mobile phone enters the hboot mode. Wait until the following figure is displayed:
The figure above indicates that s-off has been performed. If your machine is s-on, we recommend that you obtain the seller's hard solution to s-off.
2. A card reader and a memory card MicroSD formatted as FAT32 (TF card );
3. Download the firmware: http://dl.dbank.com/c0l8045pue
Start flashing
1.decompress the downloaded rarfile to get the file pd98img.zip, and place it on the SD card with a card reader. You cannot rename or decompress the file, as shown in the following figure:
2. When the phone is shut down, press and hold the volume and press the on key to enter hboot mode. After entering hboot mode, the loading progress will appear on the right, as shown in the following figure:
(If there is no loading interface, check whether the upgrade file is correctly stored)
3. The following figure is displayed after the SD card firmware is read,
Press the volume button to start the upgrade. After the upgrade appears as shown in the following figure, wait patiently. The upgrade progress will appear on the right, and the battery cannot be deducted in the middle.
As shown in the preceding figureSystemUpdated and flushed in,Manually press the power key to enterSystemYou can.
