WiFi Sharing Master Mobile phone connection is always in the IP access status?

recently, users have responded to us with the question of what to do when a WiFi-sharing guru creates a successful phone connection that is always in IP access, and the WiFi sharing guru teaches you how to solve the problem of how the WiFi share master has been in IP access when creating a successful phone connection.

The WiFi sharing master was created successfully, but what happens when the phone is connected to an IP-acquired state?

1, disconnect the WiFi hotspot, right click on the WiFi sharing master tray in the lower right corner of the computer, and choose to close the hotspot and exit.

2. Detect the PC side firewall is closed, if not closed, turn it off.

①windows Firewall Shutdown Method:

Right-click the small computer icon in the lower-right corner of your computer, choose Open Network and Sharing Center, and then click Windows Firewall.

Choose to turn on or off the firewall and close the firewall.

②eset Firewall Shutdown method

Method One: Set into learning mode

When you open it, locate the Settings button on the right toolbar

After you open settings, and then find advanced settings, the red box below, and then click in to select "Personal Firewall", and then set the mode into a learning model, the same as in addition to the default "automatic default", the other two models are the same, and then determine the finished!

Method Two: Manually shut down the firewall

Right button it down the right corner of the eset tray icon, pop-up screenshot below:

Alternatively, locate "Personal Firewall" under "Network" in "Settings", and then click "Enabled" on the left to select disabled mode.

③ mccafés McAfee Firewall Shutdown method

1, turn off the firewall protection, as shown in the following figure:

Or close the firewall as shown in the following illustration.

3. After you reopen the WiFi sharing master, after the WiFi hotspot is created, use your phone to re-enter the password to connect to the WiFi hotspot.