1, on the hard drive to establish a storage WinPE new partition
Because the volume of WinPE is often only hundreds of MB, so in order to avoid wasting too much hard disk space, we need to separate a small space for WinPE hard disk partition. Specifically, we need to perform the following steps:
First, do a good job of the last partition data backup work, then run Diskgenius, then right-click the partition where you want to install the installation WinPE, select "Remove current Partition", delete it, right-click the deleted partition, select "Partition → create New Partition", and then open the "Create New Partition" dialog box , modify the value 16 in the new partition's large skew to 15 and click the OK button.
Then click the Apply Changes button in the main interface to make the new partition operation effective. Then select "Partition → format the current partition" to complete the format of the e-disk, then the hard disk partition appears on the right side of a column called "Idle", and then the operation of the E-disk partition, The remaining part of the hard disk space to perform a new partition and format the operation of the partition can be, and finally right click on the remaining part of the hard disk space column chart, select "Partition → convert to primary partition", the F disk set to the primary partition on it.
2. Add Boot boot Menu
After the hard disk has been repartition, the next step is to add a boot prompt menu so that the WinPE in the hidden partition can be run properly even if the system crashes. The boot prompt menu is added with the following specific methods:
First run the extracted "Grubinst_gui.exe", then click the Drop-down arrow to the right of the disk radio box and select (hd0) [41863MB] (this parameter means the total size of your own local hard disk, different computers are not exactly the same); and then click Partition List The Refresh button on the right, click the drop-down arrow to the right of the partition list, and select the new entire disk (MBR) option that appears inside.
After you have done this, check the "Do not search for floppy disk at startup" and "boot to original MBR" checkbox below the options "." Set the "Wait Time" and "Hotkey" parameters (for example, the former is 3, the latter is F9), and finally click the "Install" button, a DOS prompt window will pop up, press ENTER at this time, It completes the add operation of the boot prompt menu.
3, WinPE installation and partition of the hidden
Double-click the downloaded WinPE package "Winpe.rar" and extract it to the root directory where you want to install the partition to complete the WinPE installation operation, then run Diskgenius, right-click the column chart of the partition, select partition → hide current section, and then click Apply Changes button and close the Diskgenius, the partition's hidden operation is complete.
After you have done this, reboot the system and when the "press F9 to start GRUB ..." Prompt is pressed, click F9 shortcut, and then you can see the WinPE boot menu, and in the Startup window, select "Start Windows PE" and press ENTER. You can start the WinPE normally.