Wireless routing D-LINK desktop laptop wifi Internet Settings, d-linkwifi

Wireless routing D-LINK desktop laptop wifi Internet Settings, d-linkwifi

Wireless routing D-LINK desktop laptop wifi Internet Settings here suppose your wireless routing is D-LINK, the specific address you can see the back of the route, generally have written, the example here may be different from yours, but it can be imitated.

Right-click the computer icon at the bottom right of the desktop to open the network and sharing center,

Open the properties of the local connection and double-click Internet Protocol Version 4.

Set the IP address to 192.168.0.X (X to any number in 2-255), and the gateway to 192.168.0.1,

Use one network to connect any of the 1234 interfaces of the router LAN interface, and the other is connected to the NIC of the desktop computer

Open ie and enter 192.168.0.1. (Note that you can check the vro back or the specification. Different models may be different. If 192.168.1.1 is used, change the third 0 in this example to 1 ), enter the vro settings. The account and password are admin by default. there are two different options after entering. select manual settings here!

In the Internet Connection Setup Wizard, select the connection type, find pppoe, and enter your account and password.

Next, set the basic wireless network parameters. You can use the default setting. It is best to set a password here to prevent someone from interfering with your network and completing the settings. The preparation is complete.

Connect your d-LINK to your ADSL cat. The sequence is the telephone line-cat-network cable-WAN port router, or any 1234-network cable-desktop.

After setting, we recommend that you back up the configuration for later use.

Finally, to save time for later use, set the IP address of the computer Nic to automatically obtain the IP address.

If you cannot access the Internet through the above operations, turn off the route and the cat, turn on the cat two minutes later, wait for the status light to stabilize, and then turn on the route, basically OK.