ZBrush tips: How to set the Dynamesh subdivision level

with the increase in carving details, the original subdivision of the number of surface can not meet the requirements of detail, this is the increase in the number of models to support the carving, in addition to the geometry panel can operate, We can also use the resolution parameters in the Dynamesh panel to increase the number of facets of the model to set the subdivision level.

There is a very important parameter in the Dynamesh function, that is, resolution we generally call resolution or precision, setting resolution values can increase the number of facets of the model or affect the details of the model.

The Dynamesh subdivision level is controlled by the resolution. When this parameter is set lower, then the lower the number of surface of the model, the faster the Dynamesh run, and when this parameter is set higher, the higher the number of facets of the model, the more details can be carved or better match the original model, of course, the slower the Dynamesh run. We use Dynamesh this function, do not put the resolution set too high, because Dynamesh is only in the creation of our initial use to shape large, too high to lose the meaning of the original, and the computer configuration can not bear, if we want to reduce the subdivision, Close the Dynamesh first, then use the traditional divide to improve the subdivision. The general setting of less than 128 is enough.

Note: When setting the parameters, try to use 16 32 64 128 256 of these mapping specifications, the resolution of the reconstruction subdivision is set to these values because we clearly know how much resolution, can better help us set the appropriate resolution.