PS text HOW to change lines

PS text How to change lines

Method One:

1, open Photoshop Software (each version can), I am here to demonstrate the Photoshop CS6. Open the interface as shown in the picture

2, click on the upper left corner of the "File" button, and then set the corresponding parameters, create a new picture. You can also open any picture.

3, click the Text Tool button, you can choose the direction of text and other. As shown in the following figure

4, in the need to enter the text position click below, so that the text input box appears. The position inside the red box is my text input box.

5, copy and paste a paragraph of text, you can create a new one in the computer TXT file input required text, and then operate here I will use this step of the text to sit demo. Click on the top: text---Paste---Lorenzo ipsum the following figure

Method Two:

1. The steps in the previous step of creating a new layer canvas are not repeated. When you click the Type tool to enter text, hold down the left mouse button, and then drag out the text entry box. After the process the results are as follows

2, in the drag out of the input box right click, and then select the Paste button, shortcut key for Ctrl + V. The process and results are shown below

3. Finally remember to tick the top tool panel. The perfect process and results please look at the picture below Yo!

Note:

Try both methods, perhaps because of differences in the different operating results of the version, the second method is recommended.

more knowledge please pay attention to Triple PS Tutorial column