Frame Relay configuration for routers

With the rapid development of network technology, the wide application of Internet has become more and more demanding for communication media. Frame Relay (Frame-relay) is widely used for its communication stability, speed and price concessions, and the key to the use of frame relay is the configuration of routers. Here are some common routers of the frame relay configuration, I hope to play a role:

1, Cisco router configuration

Interface Serial0 (Configure wide area port)

Encapsulation Frame-relay IETF (seal-binding relay)

Frame-relay Lmi-type ANSI

(The Frame Relay protocol is ANSI, which corresponds to the Post office end)

IP Address Port Subnet mask

Frame-relay Interface-dlci 16

(16 DLCI number assigned to this port by the Post office)

IP route IP Address subnet mask to end wide-area port IP address

2, 3COM router settings (Frame Relay part)

Set Privilege=netmgr (Authorized network Management)

Setd-ip Cont=route (Activate routing function)

setd!3-path linetype=leased (line type is a special line)

setd!4-port Own=framerelay (line type is Frame relay)

SETD!4-fr Cont=ansilmi (protocol type is ANSI)

SETD!4-ip net=11.53.240.34

255.255.255.252 (port IP address subnet mask)
Add-ip Addr IP Address @460 (460 is the DLCI number to the end)

Add-ip route to end net satin mask

On-End wide-area IP address 1 (Metric-hop number)

SETD!3-path cont=e (activation path)

SETD!4-port cont=e (activation port)

3, bdcom router settings (Frame Relay part)

Co

Chinese (choose Chinese Interface)

Quit

S0

EnCap Framerelay

IP Add wide area IP address subnet mask

Fr Local_dlci Add 16 (16 is the side DLCI number)

Map add to each other wide area IP address PVC 16 (side DLCI number)

Quit

Route Add pair end segment mask to end wide area IP address 1 (bottom hop)

Hosts add 127.0.0.1 localhost

The above is a commonly used three kinds of routers frame relay configuration, from which we can see that the key is four content: one is the line package, the second is the protocol type, three is DLCI number, four is the IP address. I hope this article will help you to make your router's Frame relay configuration.