Free Modeling Photoshop pen Path Application tips

Skills

Photoshop pen path is very important modeling tools, we also find it more difficult, the following for you to introduce some of the pen path of the application skills, hope to be helpful to everyone.

We select a point on the adjustment path, press the "ALT" key, and then click the left mouse button click on the point, when one of the "adjustment line" will disappear, and then click on the next path point will not be affected.

If you use "path" to draw a path, and the mouse is now the state is a pen, you only press the keypad on the return key (remember that the keypad on the keyboard, not on the main keyboard!), then the path will immediately become the "selection area."

If you use the Pen tool to draw a path, and you are now the state of the mouse is a pen, you just press the keypad on the return key (remember the keypad on the keyboard, not on the main keyboard!), then the path is immediately loaded as a selection.

You can delete the path directly by holding down the ALT key and clicking the mouse on the Trash icon on the path Control Board.

Hold down the CTRL key while using the other tools of the path to temporarily turn the cursor into a direction picker tool.

You can delete the path directly by holding down the ALT key and clicking the mouse on the Trash icon on the path Control Board.

Hold down the CTRL key while using the other tools of the path to temporarily turn the cursor into a direction picker tool.

Click on a blank area on the path panel to turn off the display of all paths.

When you click on several buttons below the path panel (fill the path with the foreground color, stroke the path with the foreground color, and load the path as a selection), hold down the ALT key to see a series of available tools or options.

If we need to move the whole or multiple paths, select the path you want to move and then use the shortcut key ctrl+t to drag the path to any location.

When we sketch the path, our most commonly used * is the sketch of a single line of pixels, but at this point, there will be problems, that is, the existence of moment teeth, very affect the practical value, at this time we may wish to convert its path to a selection, and then to the selection of stroke processing, the same can get the original path lines, but can eliminate the moment teeth.

Converting a selection to a path is a very useful *. This feature is consistent with the corresponding icon in the Control Panel. When this feature is invoked, the required property settings will be available in the pop-up make WORK pqth Settings window.

While using the pen tool to make a path, hold down the SHIFT key to force the path or direction line to a horizontal, vertical, or 45-degree angle, hold down the CTRL key to temporarily switch to the path picker, and hold down the ALT key to click on the black node to change the direction of the direction line so that the Pressing the ALT key to use the path picker to click the path selects the entire path, you can select multiple paths at the same time to hold down Shift-by-click, and pressing the "Ctrl+alt" key to move closer to the path when using the path selector switches to the Add node and subtract node Pen tool.

To toggle whether the path is displayed, hold down the Shift key and click on the path bar of the path palette, or click in the Path Palette gray area, and press ctrl+shift+h. To toggle the color mode directly on the color palette, hold down the SHIFT key and then move the cursor over the color bar to click.