Graphic tutorial on network connection of Hongqi Desktop 7.0

The graphic tutorial of the network connection of Hongqi Desktop 7.0-Linux general technology-Linux technology and application information. The following is a detailed description. [I = s] This post was last edited by lovemmlzy

Some netizens in my QQ group said they did not know how to connect to the Internet after installing the Red Flag Desktop 7.0. As a result, I would like to make a simple tutorial here, hoping to be useful to some netizens who use the Red Flag Desktop 7.0. The default "Auto eth0" in Hongqi 7.0 is sometimes unable to connect. For broadband dial-up Internet access, let alone, how can I connect to the Internet without an account or password.

Find the network connection icon in the lower right corner of the desktop, 1
Three on the left.
Right-click the network connection icon and select "Edit connection". The network connection dialog box is displayed.

Select "Auto eth0 ". Click Edit. The "Auto eth0" configuration dialog box is displayed.

View the MAC address of the local machine on the wired tab. Record the MAC address to prepare for the following operations.

The following operations depend on your network environment, if it is in a small LAN. Then

Click Add on the wired tab. A dialog box is displayed.

Enter the connection name and MAC address in the Wired tab of the dialog box, and check the box in front of "Automatic Connection. Select the Ipv4 settings tab. Click the "Mode" drop-down box to select an IP address allocation method. This method is similar to "internet IPv4" in XP. If you select "Manual", the IP address, gateway, subnet mask, and DNS mode are used.

When the application is finished, it will be OK.


If you are using broadband dial-up Internet access. Select the "DSL" tab in.

Click "add". In the displayed dialog box, enter the user name (broadband account), service, and password.


After setting the account and password, select the wired tab. Enter the MAC address as shown in Figure


Click "application ".