Graphic tutorial of pqpartition magician

Pqpartition magician graphic tutorial PartitionMagic, PQ, PM for short. It is a disk partition management software developed by Norton. It allows you to adjust disk partitions, repartition, adjust partition size, merge partitions, and convert disk partition formats without affecting data in Windows. However, it is dangerous to use it. Improper Operations may result in loss of partitions and data. Therefore, when operating on it, you must be clear about what you are doing, you need to be skillful in operating it. Otherwise, it will be too late to know how much data will be lost and the disk will be lost. It has two types: DOS and Windows. Generally, DOS is used for bare metal partition management. For Windows, operations are performed on the Windows interface to re-partition, adjust the partition size, and merge partitions, convert the disk partition format. The following describes the usage: 1. Use the DOS version to partition bare metal partitions. The DOS version PQ is available on many GHOST system disks. the startup interface is as follows: partition the partition concept: 80 GB hard disk, it is divided into three zones, with a C drive of 10 Gb, a D Drive of 30 GB, and an E drive of the remaining parts. Click job -- create and set the primary partition (disk C), set the partition format, set the partition size, and click OK. After completing the C-disk partitioning, perform the same steps to divide the logical partitions (disk D and disk E) after dividing all partitions, you must activate the primary partition. Many people forget this step, and the result is that it cannot be started. Activate the primary partition: select the drive C, and click "job"> "advanced". Click "OK" to make all the settings take effect. Then, complete the partitioning. Install the system.