Guide to the use of MP3 ring cutter

Use guide:

1: Click on "Input File" after the small button, open a MP3 file.

2: Click on the "Output file" behind the small button, select the location where the cut file is saved.

3: Click the "Set Start" button, will be the current playback position to cut the starting point.

4: Set the Set End button, the current playback position will be set to the end of the cut.

5: After the cut start and finish, you can click the "Test Effect" button to try to listen to the effect of shearing.

6: After the cut start and finish, click the "Start Cut" button to cut.

7: You can drag the playback Progress slider to adjust the playback progress.

8: You can adjust the cut position by clicking the small button behind "time", "minute", "Seconds", and "millisecond".

Note: If you cannot drag the progress backward through the slider after listening to the test effect, then clicking the play button will solve the problem.

Skills:

During playback, the edge-listening side sets the start and end points of the cut, which can be more precise in determining the cut position. Therefore, you must play the music before setting the clipping point.

Fine tune the clipping position by clicking the small button behind "time", "Minutes", "Seconds", and "milliseconds".

If you set the cut position during playback, the playback progress will immediately go to the settings point and you can clearly hear the cut position.

Click the "Test Effect" button before cutting to reduce the actual number of cuts and get the actual effect of the cut in advance.

If a player is playing a clip before cutting, it is recommended that the player be turned off and the file read and reread may appear on Vista and Win7 systems.

Registration method:

After obtaining the registration code, click the Menu "Help"-> "register", pop-up registration window

Enter the registration code in the Registration window and click the "Register" button

If the registration is correct, you will be prompted for a successful registration or an error message is displayed

If there is no registration code, you can click the "Software Trial" button for trial, the system has a certain number of trial times, the use of the number of uses, if you want to continue to use, need to purchase a registration code.

Registration and trial need to authenticate the identity through the server, so be sure to ensure that the computer connected to the Internet, and firewall prompts when the firewall to unblock the software.