Ha configuration for Radware alten Series

Use The following parameters are configured when VRRP redundant mode. The configuration of this chapter, primarily with the device configuration.

1.1.1enabledVRRP

>> main#/c/l3/vrrp/on

1.1.2ConfigurationVRRP

the VRRP address is required on all 2 switches

1. Specify the virtual route ID

>> main# /C/L3/VRRP/VR 1       

2. Enable this virtual route

>> VRRP Virtual Router Ena

3. Specify vrid

>> VRRP Virtual Router Vrid Ten

4. Specifies the interface that corresponds to the VRRP address

>> VRRP Virtual Router if 1

5. specifying the prio parameter

>> VRRP Virtual Router Prio

6. Configure VRRP address, this is floating IP,VIP also need to configure.

>> VRRP Virtual Router Addr 19.128.253.17

other The VR configuration is as follows :

/c/l3/vrrp/vr2/ena/ipver V4/vrid 2/if 1/addr 19.128.253.18

/c/l3/vrrp/vr20/ena/ipver V4/vrid 20/if 2/addr 19.128.1.4

/c/l3/vrrp/vr100/ena/ipver V4/vrid 100/if 10/addr 1.1.1.10

enabled Goup Group

/c/l3/vrrp/group/ena/ipverv4/vrid 254/if 1/prio 101

create one for each interface, respectively Vr.

Routerid : Define the ID number of the VR , note The ID number in the same Vlan do not conflict with other devices

Status : Define the status of the VR needs to be set to enabled.

Interface : Define ports Used by VR

Priority : Define VR priority, Max 255. Primary device with high priority, the main device is usually set to 101

1.1.3Configuring synchronization Parameters

Peer command to define synchronous communication of the standby machine IP , we can use ISL IP , do not use administrative IP .

/c/slb/sync/priosd/state E

/c/slb/sync/peer1/ena/addr 1.1.1.2

1.1.4 hotstandybyParameters

Port 8 is used to interconnect and synchronize configuration information. Activate hot Standby on port 1.

/c/slb/port1/client Ena/hotstan Ena

/c/slb/port2/server Ena/hotstan Ena

/C/SLB/PORT8/INTERSW Ena

1.2Standby MachineVRRPConfiguration

you need to configure synchronization parameters to specify the host's IP address.

/c/slb/sync/priosd/state E

/c/slb/sync/peer1/ena/addr 1.1.1.1

1.3Synchronization Configuration

After the new configuration or modified configuration, the host's changes need to be synchronized to the standby machine, you can refer to the following steps to achieve.

1. Synchronize the SLB configuration by executing the following command

>> main# /oper/slb/sync

after synchronization, the standby automatically executes the apply and save commands.

after normal operation, the host's the VR state is master, which indicates that the business is being processed. The following are examples of operations:

>> main# /oper/slb/sync

Note:use the "/c/slb/sync" menu toconfigure omitting sections of

The configuration.

Synchronizing vrrp,filt, PORT, SFO State, BWM and SLB configuration

To 1.1.1.2

confirmsynchronizing the configuration to 1.1.1.2 [y/n]: y

Configuration on1.1.1.2 have now been synchronized.

2. then check that the standby configuration is synchronized.

Ha configuration for Radware alten Series