HDD installation system reboot prompts disk BOOT failure failure to enter the system how to solve

When a user has recently installed a system with a hard disk, the computer will display disk boot Failure,insert system disk and press ENTER (as shown in the following image) after the reboot, which means that the disk failed to boot, plugged into the system disk, Press ENTER again. In other words, the system in the installation of the disk encountered errors, failure or hard drive data cable interface loose, below to see the specific solution.

1, the boot directly press F8 into the Safe Mode interface.

2, select the option "Last Known Good Configuration" to start the system, press ENTER will restart the computer system, a little wait a moment the system has successfully entered! The operation is very simple and easy to use, small knitting computer appears this situation is so solved. If your computer is still unresolved, see the breakdown below.

Disconnect the chassis and reseat the hard drive data cable interface

1, if the above methods still can not solve the problem, then first take apart the chassis, the hard disk data cable, as well as the data line interface, the data line first pull out, clean up the dust and then inserted.

2, if it is a notebook computer, directly unscrew the screws, plug the hard drive. Then the boot into the BIOS interface, or the Power-on interface when press pause break button to stop the screen to see if the hard drive is displayed.

3, if the BIOS interface has seen the hard drive has been connected, if the system does not go, then the system boot hard drive failed.

One, take a system disk, repair system boot.

Second, or boot into the system, then only reinstall the system.

Another solution:

This kind of fault occurs in the hard drive is not detected in the case, first of all to enter the CMOS settings select "IDE HDD audo detecdion" project to see if the hard drive can be detected, if not detected the hard drive, it is possible that the hard drive out of the problem.

You can tear down the hard drive, in other computers, if not detected, it must be hard drive bad, if the other machine can be correctly detected on the hard drive, it may be your hard disk data line problem, plug in or change the data line to see, there is power; Verify that the size of the hard drive and other parameters are the same as the actual hard drive parameters;

The same parameter is not a problem with the hard drive.

All the above, (the hard drive is no problem) on your computer or ... That means there is a failure on the motherboard.

The summary is: Check the data cable and power/hard drive and Parameters/final motherboard.

About the boot prompts disk boot failure disks encountered error problems, you can follow the tutorial to fix the solution, I hope that the problem of the trouble you have to help.