How can I cancel the computer network speed limit when the computer network speed is slow?

1. Press Win + R. After "run" is displayed, enter "gpedit. msc" and click "OK", as shown in the following figure;

2. After entering this page, we will go to the group policy: computer configuration-management template-network-QoS packet scheduler, find and double-click "limit retainable bandwidth", as shown in the following figure;

3. After entering the page, find "enabled" on the page. In the options below, change the bandwidth limit from 20% to 0%. Click "OK.

In this case, if your bandwidth network is slow, the computer will be shut down. In this case, there will be no reduction in the inbound and outbound bandwidth. Of course, if you cannot, we can try the following solutions:

1. Log on to the settings page. In the browser, enter 192.168.1.1 and press Enter. Enter the user name and password (admin by default) and click OK ".

2. Click "IP bandwidth control" --> Select "enable IP bandwidth control" --> Select "ADSL line" for "broadband line type" (please select according to your bandwidth service, if you do not know, please contact your broadband carrier by phone) --> "total upstream bandwidth" fill in: 2048 --> "total downstream bandwidth" fill in: 4096 --> Click "save ".

Note:

(1) fill in the bandwidth you handle for "total downstream bandwidth". Note the unit conversion: 1 M = 1024 Kbps = 128 KBps, that is, 1B = 8b; the above is a 4 m bandwidth, so I entered 4096 Kbps. If the unit of your vro is KBps, then the 4 m bandwidth should be 512 KBps.

(2) set "uplink total bandwidth" to half of your "downlink total bandwidth.

3. Click "add new entry"

4. Fill in "start address": 192.168.1.4 --> "end address": 192.168.1.254 --> fill in poor information in the "downstream bandwidth" and "maximum bandwidth" columns: 1024 --> Click "save ".

Note:

(1) the figure above indicates that each device connected to wifi on the vro can only use 1 Mbps of bandwidth. If you want to limit the maximum bandwidth of a device to half M, enter 512. Enter the values in the other three boxes as needed.

(2) Fill in "start address": 192.168.1.4 --> "end address": 192.168.1.254, set the IP address of your notebook to 192.168.1.2, and set the IP address of your mobile phone to 192.168.1.3, therefore, the network speed of your laptop and mobile phone when connecting to wifi is not limited.