How do I change the physical IP address of the SP of VNX Unify?

Solution:

Starting from VNX File OE 7.0.35.3 or Block OE 05.31.000.5.502, you cannot directly change the SP ip address from the Unify interface. You need to use the command line program to change the ip address.

 

Changing the physical ip address of the SP will cause the CS to be unable to access the SP. Do not modify the ip address unless otherwise specified!

 

Log on to CS0 using SSH, and use the username nasadmin and password nasadmin.

 

Run the following command:

 

#/Tftpboot/bin/javaseccli-h-User sysadmin-password sysadmin-scope 0 networkadmin-set-ipv4-address xxx. xxx-subnetmask quota 255.255.0-gateway xxx. xxx

 

Prompt warning information, select Y

 

 

Changed successfully.