How does a computer install two Fuji Xerox network printers?

　　To install the printer driver:

1. Download and run the driver on the official website and click Customize:

2. Select Local printer and click Next:

3, any choice of a port, and then select the corresponding model of the new printer, click Next:

4, click on the selection is, and then click Install:

5, wait patiently after installation completes, then click Completes, is:

　　To configure printer settings:

1, open the printer and fax in the Control Panel, then right click on the installed Fuji Xerox printer, select Properties:

2, click on the port, and then click Add Port:

3, because it is a network printer, so select Standard TCP/IP port, and then click on the new port:

4, enter the IP address set on the new printer and rename the IP address, click Next:

5, wait a moment, after system configuration completes, click completes:

6, click on the new port configuration Interface closure:

7, as shown in the following figure, the new configuration of the port will be automatically checked, and immediately effective. Click Apply, and then click Close:

　　To print a test page test:

1, right click on the installed printer, and then select Properties:

2, click the printing preferences, or print a test page, or directly use the printer to print the required documents, and so on, test whether the printer installed successfully: