How does a soft route of sea spider realize the vpn Cabling Process?

The demand for the soft route of sea spider in the soft route market is still very high, and its performance is also very good, maybe many people do not know how to use the soft route of sea spider through the vpn line, it does not matter, after reading this article, you must have gained a lot. I hope this article will teach you more things. I believe many of my eldest brothers have already learned and done well by Using VPN connections. Here, my younger brother is still here to popularize this knowledge.

VPN cabling is generally used to enable a single-line Internet cafe to implement a two-line advanced sea spider soft route through VPN without adding access lines, thus solving the bottleneck of communication between China Telecom and Netcom. Compared with the cost of pulling a fiber, the VPN borrow line will be much more cost-effective, and if you have an acquaintance's Internet cafe with two lines, then you can directly ask him to serve as the VPN Server to provide you with the borrow line service. It is said that single-line access to a single line can also prevent communication and Netcom from blocking ADSL Internet sharing. The test is not yet complete.

If you want to borrow a line, you must use a route that supports VPN and support the routing function of the virtual dual-line policy. Currently, hard routing is not available to support this function, both HSROS and RouterOS can be implemented in the soft route of sea spider, and can be interconnected when PPTPVPN is used. Because ROS's offline tutorials have been written by many older brothers, the younger brother will not be ugly. The following uses HSROS as an example to briefly explain the setup process.

Server

Log on to the WEB management page of the sea spider soft route, click "Service Management"-"pptp vpn" here, configure as follows: Click to enter "VPN user management" to create a VPN account. Finally, select "firewall"> "Basic Security Settings"> "advanced mode.

Client

Log on to the Management page, click "access settings"-"PPTP connection", and dial through the account created on the server:

My personal experiences on Using VPN connections are shared with you.

I will not elaborate on how to configure the VPN server and client on a router. It is clear in the tutorial. I believe you will see it. As for some friends, it is not possible to borrow a line. I would like to remind you that the following services are enabled on the PPTP server: LDAP DBS, PPTP VPN, and RADIUS Auth for SSL VPN. You need to enable an SSL-based VPN.

First, the authentication protocol between the VPN Server and the client must be synchronized! What is selected by the server. Your client must be the same as the server. Second. Data Encryption must also be synchronized. Otherwise. You cannot dial it either.

Second, create the account and password of the client in VPN user management. Select the corresponding VPN. For example, if you are using PPTP, select PPTP. You are an ssl vpn. Select ssl vpn.

Third, start the soft route of the virtual sea spider in the advanced policy route, and select your VPN mode in the virtual line mode. Set the line. Set the line detection. . You can test the line detection PING of your virtual line and write your VPN gateway.

Fourth, when the VPN Server sets the address range. Try not to share a CIDR Block with your local area network.