Why hide
WiFi
Signal?
For most users, the purpose of "hiding" signals is to prevent others from finding their own signals, thus reducing the risk of network attacks. As a matter of fact, this can indeed achieve better results, because illegal terminals cannot find signals, and thus they will not be able to rub the network. However, hiding signals also makes it inconvenient for you to use wireless networks. For example, it is inconvenient for a terminal or visitor to connect to a signal.
We provide a variety of methods to prevent network attacks. You can refer to how to prevent network attacks?
How to hide it?
By default, the radio signal enables the external broadcast signal. You only need to log on to the vro management interface and disable the broadcast switch.
Open the computer browser, enter the management address (tplogin.cn or 192.168.1.1 by default) of the router in the address bar, and enter the management password to enter the interface. Click
Route settings
>
Wireless Settings
Enable wireless broadcast
Remove the preceding check box and click
SaveThen, the signal is hidden.
For older vrouters, log on to the vro management page and click
Wireless Settings
>
Basic settings
Enable
SSID
Broadcast
Remove the preceding check box and save and restart the vro.
Can someone else find the hidden information?
After the wireless signal is hidden, no signal is found on all mobile phones and tablets. Computers that have not connected to the signal can find the signal but cannot identify it. The specific situation is as follows:
Type
|
Previously connected to this signal
|
I have never connected to this signal before
|
Computer
|
Signals can be searched
|
Unidentifiable signal found
|
Mobile phone
/Pad
|
No signal found
|
No signal found
|
Note:The XP computer cannot find the hidden signal.
After the signals are hidden, the signals found by other computers are as follows:
How can I access the internet after hiding my terminal?
If no hidden signal is found for your terminal device, such as a purchased wireless device or a guest terminal, you must manually add a wireless configuration file to connect to the device. The setting methods vary depending on the operating system.
