Xiaoxin Air13 Pro comes standard with a pressed fingerprint that can be unlocked to enter the system. How can I set fingerprint input?
Frequently Asked Questions about fingerprints:
1. How many finger fingerprints can be input at most? ---- The number of entries tested is 10, and the system prompts you to add more entries. The maximum number of entries must be greater than 10.
2. What should I do if I press the fingerprint multiple times and the progress bar does not go? -- Wipe your fingers and fingerprint sensors with a clean paper towel, and then tap the fingerprint sensor with your finger.
3. Does the fingerprint support a wet hand unlock code? --- Not supported. You need to use a clean paper towel to clean your fingers and fingerprint sensors, and then tap the fingerprint sensor with your finger.
Solution:
There are two methods to input fingerprints:
1. Fingerprint input during system setup of new machine startup
A. Windows Hello is welcome. Click "next ";
B. Start to press the fingerprint sensor with your finger until the "Read entry" is reached;
C. Then, the system will prompt you to enter the PIN code, in case of fingerprint failure, you can enter the system through the PIN code;
D. Press the fingerprint directly after the device is started. You can enter the system without entering the password.
2. The fingerprint entry step is skipped during system setup of the new machine. After entering the system, you want to set the fingerprint.
If you do not enter fingerprints when you set the system for the first time when you start the system, how can you set fingerprints after you enter the system?
A. Click "Start menu" in the lower right corner of the screen and click "set ";
B. Click "account ";
C. Open "Login Options", find the fingerprints under Windows Hello, and click "set ";
D. Click start ";
E. First, set a PIN code. Make sure that the fingerprint can be entered through the PIN code if the fingerprint cannot enter the system;
F. Press the fingerprint until the progress bar is reached;
G. If you want to add another finger's fingerprint, click "continue adding.
