I am a China Telecom broadband of 2 m, and ADSL cat is Shanghai Bell homeaccess. After using amule, it has always been a low ID,
The download speed has been more than 10 KB. I think the bandwidth of 2 Mb is too wasteful. I went online to check how to get high. After two nights of struggle, I finally found the result, because I found that there was basically no setting method for this cat on the internet, I shared the setting method for this cat, which should be helpful to others, haha.
1. Not to mention downloading and installing amule, haha.
2. Set the TCP port and UDP port of amule, which can be any number, but not 4662 (TCP) or 4672 (UDP) (I don't know why). I cannot set this anyway, I set 10000 ).
3. Enable cat routing:
Enter http: // 192.168.1.1/in the browser, enter the password, admin/admin by default, and select [device information] [statistical table] [Wan] To observe the traffic, write down its VPI/VCI values, select [advanced settings] [Wan] to delete all interfaces, and click [add] to enter the VPI/VCI value, service type UBR without PCR, next select pppoe, encapsulation mode LLC, next enter the user name and password provided by China Telecom, add pppoe service name casually, next enable WAN service, next save, then save/restart.
3. Set port ing:
After the cat restarts, your system can directly connect to the Internet without pppd virtual dialing. At this time, enter the vro setting interface, select [advanced settings] [Nat] [Virtual Server], click [add], select a custom server, enter amule or another, Server IP Address: Your LAN address, (My 192.168.1.2, ifconfig can see that eth0 is)
In the following table, enter the TCP port of amule (My 10000, as set earlier) for all ports in the first line, and select TCP as the Protocol, all ports in the second line enter the UDP port of amule (My 10000, as set earlier), and select UDP as the Protocol. [Save/apply] OK.
4. Restart the cat and then restart amule, which should be high id.
Additional:
A. The setting principles of other routers are similar, that is, port ing,
This address has many router settings, http://board.verycd.com/t98072.html
B. This address can be used to test whether your port ing is successful. (To open your amule) http://www.emule.org.cn/porttest? Tcpport = 10000 & submit = % B2 % E2 % A1 % A1 % CA % D4
C. Security reminder: promptly change the cat's password.