How does iphone6 plus get into DFU mode? Apple 6 fast into the DFU mode method (1/3)

Before the tutorial begins, we need to understand the two key keys to entering DFU-the power and home keys, which are located at the top of the iphone and below the screen, as shown below.

Normal restoration of Law I.

1, turn your iphone off.

2, at the same time press and hold the switch machine keys and home keys.

3, when you see the white Apple logo, please release the Switch machine key, and continue to hold down the home button.

4, open itunes, waiting for its prompt you into the recovery mode, you can hold down the keyboard shift button, click "Restore", select the appropriate firmware to restore.

Some users in the point of control is not good, leading to the failure to enter the DFU mode, these users can refer to the following method:

1, hold down the top of the Power key 3 seconds;

2, do not release the Power key while holding down the home key for 10 seconds;

3. Release the Power key and continue holding down the home key for 30 seconds until itunes automatically detects a recovery-mode iphone and then loosens it.

Second, black screen restoration

1, connect the iphone with the USB cable to the computer, and then you will hear the computer has been connected to the success of the sound of the prompts.

2. Now please turn off the iphone first, then you will hear the computer is not connected to the successful sound of the message.

3, please hold down the switch machine key and the home key, continue to the first 10 seconds, please immediately release the key, and continue to hold down the home key.

4, this time itunes will automatically start, and prompts you to restore Mode (the iphone will always keep the black screen state), then you can hold down the keyboard shift button, click "Restore", select the appropriate firmware to restore.

Method III, using software to enter DFU mode

Some users in the brush custom firmware, through the above two methods to enter DFU mode, there will be errors, can not brush custom firmware, this time need to use some software to guide into the DFU mode, the common software has iREB, Ifaith, Red Snow, sn0wbreeze and so on ( In fact, Ifaith and Sn0wbreeze are built into the iREB to guide. The following is an example of how to enter the DFU through the iREB in Sn0wbreeze, ifaith reference to this tutorial.

1, open Sn0wbreeze, click on the upper left corner of the "iREB", select "Run iREB", jump to the iREB boot interface.

2, Sn0wbreeze will ask whether it is Apple TV 2, choose No.

Home 1 2 3 last