How does the computer set the hard drive to boot?

Our computer is usually started from the hard disk, but in some cases, may be set on some peripherals to start (such as USB flash drive or mobile hard disk), so, the boot appeared not hard disk boot, how should we modify the hard disk to start?

Tools/raw Materials

Computer

Method/Step

First of all, if we open the computer, this time need to restart the computer, if not open the computer, directly press the boot button on it. PS: Try to close all programs, so the damage to the computer is the least, we use the ThinkPad computer as an example. )

After reboot, in the boot page must pay attention to observe the English page, this time need to remember to enter the BIOS Settings keyboard button (PS: Different computers to enter the BIOS settings are different, must not disorderly press, according to the boot page to determine, this computer is the return key. )

At this point, into the BIOS Setup window, we need to find him first "Advanced BIOS (Advanced BIOS features) option" Inside, look carefully, will find, and then double-click it, enter the new page. Of course not the computer is different, need to observe carefully, it is best to check English at any time. (PS: The computer in the settings, that is: "Startup")

In the new pop-up window, we need to carefully find the "boot devlice priorfty (boot device order)", this time still double-click it to enter the new page. If not, you need to find the boot, and the ENTER key will come out of the new window. (PS: This computer is the click of the boot)

In the new page, we can see the top 1, 2, 3 three items (some BIOS is 1st boot device;2nd boot device;3th boot Device), representing "first start, second start, third start", You can look at the picture carefully. (This computer is all in numbers.) )

After we find it, we need to modify it according to the prompts below the page, and set the order to "hard disk-hdd; The mobile device is USB; The optical drive is CDROM". (PS: According to the picture we can find that this computer's hard disk bit is very hdd0, according to the tips below the page and the left to help modify it.) )

After the completion of the setup, we generally use F10 to save (PS page also has a hint at the bottom), in the pop-up dialog box, we choose or enter "Y" to save, this time the computer will automatically restart, our settings will be effective. (This computer can hit the enter key directly in the Yes place.) )

　　Attention matters

Be sure to follow the steps and do not tamper with other contents of the boot.

The above is how the computer sets the hard disk to start the method introduction, hoped can be helpful to everybody!