Based on different home broadband lines, three access modes are available: network cable, telephone line, and optical fiber. For specific connection methods, see the following dynamic topology.
After the connection is complete, check whether the router indicator is normal:
Before setting a vro, you must set the operating computer to automatically obtain the IP address. If your computer's wired network card has been set to dynamically obtain the IP address, you can directly perform step 2.
1
, Enter the management address
Open ie on the desktop, clear the address bar, and enter
192.168.1.1(Default vro management IP address). After you press enter, the logon window is displayed.
2
, Logon Management Interface
Enter the user name and password at the corresponding location, and click
OK. The default username and password are both
Admin.
If you cannot log on to the management page after entering the management address, click to reference:
1
Start setting Wizard
Go to the vro management page and click
Setup Wizard, Click
Next Step.
2
, Select the Internet access method
If you use the bandwidth account and password allocated by the carrier for PPPoE dial-up Internet access, follow the instructions in the article to continue setting. If you are using another method, Select
PPPoE
(
ADSL
Virtual dialing)
, Click
Next Step.
3
, Enter the Internet broadband account and password
Enter the broadband account and password provided by the carrier in the corresponding settings box, and confirm that the account and password are entered correctly.
4
Set wireless parameters
SSIDThat is, the wireless network name (which can be set as needed). Select
WPA-PSK/WPA2-PSKSet the PSK wireless password and click
Next Step.
5
, Set
Click
CompleteThe setup wizard is complete.
After setting, go to the vro management page and click
Running status, View
WANPort statusIf the IP address is not 0.0.0.0, the setting is successful.
Now, the network connection is successful and the vro has been set up.
