How hard disk Protection (EDU) implements incremental and shared transmission

Solution:

HDD Protection 7. After the X version, the network has only one intelligent biography with the cross, no previous 6. The increment of the same function in X. This is not to say does not support the increment of the same biography, but only unified to the intelligent same transmission, that is, the software automatically determines whether the current system and the previous system has a difference between, if there is, then the increment of the same transmission. To achieve an incremental share, the following conditions need to be met:

1, the launch side uses the hard disk protection management function to create the partition, cannot use the Third party tool software partition.

2, the installation of the operating system, the system under the computer hardware drive, as well as the corresponding correct version of the system drive protection drive, to determine the protection function can be achieved. and format all data areas, and if you install more than one operating system, you also need to format the corresponding partitions to ensure that no unformatted partitions exist.

3, launch terminal installation application software and system configuration, to determine the launch end of all installed on the receiving end of the intelligent same pass.

4, to ensure that the launch side does not enter into the open mode after (that is, the launch end do not press Ctrl+o or set the unprotected state).

5, if there is software to be updated or installed, in the protection mode into the launch side, the installation of the need for incremental software. After installation restart the computer into the hard drive protection of the boot menu, in the selection of operating system interface on the CTRL+B to save data, and then press F4 into the network with the same biography. At this point, select the intelligent same transmission can realize the increment of the same transmission function.

Note: In order to achieve the incremental same transmission must be the same transmitter in the protection mode of the same transmission, and after the launch end can not enter the open mode (that is, can not press the Ctrl+o), in the protection mode of the transmitter installation software and then through the ctrl+b to save the data, after the same transmission is the increment of the same biography. If the transmitter has entered the open mode or installed the software in protected mode without pressing CTRL+B to save the data, then the incremental same-pass function will not be implemented.