How should beginners learn and even play a good Linux system?

I have some previous learning experience and methods to share with you, I hope to help you:

first, to play a good Linux must often toss, plainly, is the ability to do the job must be strong. I beginner Linux that piece, home 3 computers, I often repeatedly on the above do Kickstart, network Ghost, dual-system installation experiments. For a long time , I also installed the Ubuntu system in one of the old-fashioned notebooks, through which I can visit the web and watch video, solve various driving problems, and through these tossing and taking, the more and more interested in Linux, the more and more the motivation of learning.

Second, the bedside often put a few books, before bedtime or bored often turn over, my personal feeling is the dead of the night when the impression is very deep, a lot of knowledge points are easy to remember.

third, I am accustomed to put a small book at hand, some of the new Linux operating words I will write on the above, the detailed usage will be recorded, and so on people or eat when I will take to turn over, so feel mastered particularly fast. English headache students suggest sticking to the American drama of English subtitles, such as the popular "Life Big Bang", "Pride Yin Wife", "the Game of power" and so on, I believe that English will not become an obstacle to learning.

Four, the experimental process of the barrier must pay attention to the cause of the error, such as I recently found myself PXE installation of the experimental machine, always bring a Ifcfg_eth0.bak file, and then after careful analysis, found that my machine is Kickstart installation, sub - with the Mac and the original machine is inconsistent, the machine restart service after the automatic addition of a Ifcfg_eth0.bak file, know the cause of the failure after the good run. Work encountered problems, should also be repeatedly to troubleshoot, do not make a mistake in the premise of the reason for speculation, this effect is very bad. You can see the problem of the network card file, the following assigned MAC address is actually not the same as the MAC address of the system NIC itself, as follows:

[email protected] network-scripts]# Cat Ifcfg-eth0.bak # Realtek Semiconductor Co., Ltd. rtl8111/8168b PCI Express Gigabi T Ethernet controllerdevice=eth0bootproto=nonehwaddr=fe:ff:ff:ff:ff:ffonboot=yesnetmask=255.255.255.0ipaddr= 192.168.1.120gateway=192.168.1.1type=ethernet

Five, if you have a complex problem or think for a long time there is no answer to the knowledge point, suggest you can go to see someone else's blog, learn others experiment and experience, and then digest, absorbed into their own, here is recommended that everyone must do a good job notes, a good memory than a bad pen, a little knowledge, long-term persistence is a very considerable value.

Six, encounter new technology or difficult problems, first experiment, then the principle, do not understand this classmate first in accordance with my method to try, slowly understand.

These methods in your insistence, long-term adherence to the words, there must be a harvest.

This article is from the "Fuqin Wine" blog, please make sure to keep this source http://yuhongchun.blog.51cto.com/1604432/1572162

How should beginners learn and even play a good Linux system?