How to enhance WiFi signal strength

Enhanced WiFi signal strength and coverage via "bridge"

When a wireless router (temporarily referred to as the "primary router") produces a weaker WiFi signal, we can enhance the WiFi signal strength and coverage by using another wireless router with "WDS" (temporarily referred to as a "secondary router") in a "bridge" mode.

The specific methods are as follows:

Login to the secondary router background management, switch to the "Wireless Settings"-"Basic Settings" tab, check the "Open WDS" item.

When the WDS feature is turned on, the expansion panel shown in the picture appears, where we can directly enter the WiFi name of the main router as well as the "BSSID" (Network MAC address), the key, or by clicking on the "Scan" button to automatically search the surrounding WiFi signal.

When you click on the "Scan" button, you will open the AP list interface, find the WiFi hotspot for the bridge, and click the "Connect" button.

The "WDS" bridge interface will be responded to, and the corresponding WiFi "SSID" and "BSSID" will be filled in automatically, where we only need to enter "key" and click the "Save" button.

You will be prompted to "you have changed the wireless settings, the restart after the", this direct click on the ' Restart ' button, to be the secondary wireless router restart completed, the Network Bridge function, its wireless WiFi signal and coverage has been significantly improved and expanded.

Homemade WiFi signal intensifier

When the WiFi signal generated by the wireless router is weak, we can make a homemade WiFi signal enhancement device to enhance the WiFi signal as much as possible. First we have to find a "can", clean it, believe this should be easy to find.

Next we need to remove the "ring buckle" of the cans, so that the purpose of the wireless router is to insert the antenna from this hole to install.

The use of "scissors" or "knife" can be cut at the lower part of the cans, in the removal of the lower part of the cans to be cut at the red line.

The top part of the can is removed and the part of the water hole is retained in the removal, as shown, so that the purpose is to facilitate the development of the side of the soda can.

Next to the "drinking mouth" part of the center, the cans can be cut into two parts, as shown in the picture:

Finally, the side of the cans to expand into a fan, while the water hole daochamen to the antenna, using soft glue will be the top of the cans fixed to the wireless router. To close the homemade wireless signal amplifier on the production completed.