How to cancel Thunder look at boot up

Install good Thunder to see after the software will start to boot, so that the boot speed slows down, how to cancel the boot up? I do not know the students to see this article Introduction bar.

That's really annoying. Because the thunderbolt to see the use of Peer-to-peer technology, will automatically upload files, a portion of the bandwidth.

So, how to cancel the Thunderbolt look at random start it? Look down.

When you see this problem, do you think about 360 the first time? With the 360 security guards to optimize the "start" is not OK.

That's what I thought, too. In fact, the 360 security guards in the optimization of the "launch", in the launch of the Thunderbolt did not see, but the next time the boot, the Thunderbolt to see or randomly started.

It's weird! 360 can't even surrender thunder to see.

Is there any other way? The bell still needs to fasten the bell person, then starts from the Thunder to look.

First, open the Thunderbolt to see;

Then, click on the button in the upper left corner and click "Settings" in the Drop-down menu.

Finally, uncheck "Start up" in the system setup.

The following figure:

After canceling the check, the Thunderbolt will never start randomly!