How to partition a new hard disk using Diskgenius

Diskgenius is one of many hard disk partitioning tools, common in many ghost packaged operating systems. So, learning to use Diskgenius to partition a new hard disk is the first step to installing a system. The following details how to use Diskgenius to partition a new hard disk.

Diskgenius

New hard disk not partitioned (also available for virtual hard disk emulation)

　　First open Diskgenius, see the main interface, the right side of the word "HDD" is to partition the hard disk, because it is a new hard drive, the partition information on one side are still empty

　　Select the hard disk you want to partition on the left, and then click New section on the toolbar.

　　New Partition dialog box, the partition type first select "Primary disk Partition", that is, will install the system partition, size of their own decision, here installed XP so set to 10GB enough, after the set up click "OK"

　　Back to the main screen, see the green border of the partition status bar, first click on the mouse to select, that is, select the remaining unpartitioned parts

　　And then the same, as in step 2, click on the Toolbar "new section", but this time the partition type select "Extended Disk Partition", the size does not change to keep the default, that is, in addition to the main partition of the remaining disk space size, set the point "OK", so that the extension of logical division out

　　Next, like Step 2, select the extended partition that the red arrow in the picture refers to, and then click New section on the toolbar.

　　This is the logical partitioning of the partition on the extended partition, the size of the logical partition can be customized, that is, the number of disks and the size of each disk is determined by their own, after the election "OK." Repeat this step if you have any more points.

　　See the partition status bar, the primary and extended partitions are in a good state, then you can click on the toolbar "save changes" to allow Diskgenius to perform the previously set partition operation, the period will be prompted to format the partition, click "Yes" agree

　　After all work is done, see the partition status shown similar to the picture, the partition operation is successful, restart the computer can be effective

Note : More wonderful tutorials Please pay attention to the triple computer tutorial section, triple Computer office group: 189034526 welcome you to join