How to reset win7 system network settings by command

Computers in the process of connecting the network will inevitably encounter a variety of failures, cause the network can not be used normally, the Bean System Small series in the previous tutorial also on the network fault issues are introduced, such as router IP address error can not connect network resolution, network configuration error can not connect, etc., these network problems are also to find out why. The right remedy "to solve, and sometimes need to recharge Windows network settings to solve the problem of the network, below to introduce the use of commands to reset the win7 system network settings operation method, I hope that we can play a certain role in helping.

To reset the W7 system network Setup method by command is actually relatively simple, the specific steps are as follows:

First, click Start, Run, cmd (run by the administrator);

Two, and then run the following commands separately:

1.NETSH INT IP RESET

2.NETSH WINHTTP RESET PROXY

3.ipconfig/flushdns

Third, after all the above operations are done, directly restart the computer, so that the use of commands to reset the Win7 64-bit network settings even if it is done.

The above is a command to reset the Ghost Win7 System Network settings method, which is also suitable for use in other Windows operating systems, of course, we can also use other methods to reset the network settings, this side is no longer one by one elaborated.