How to set up a wireless router

Today's wireless products are cheap, and many families have bought wireless products to fully enjoy the fun of wireless internet. Many users often encounter the problem of setting up a wireless router, which leads to the eventual inability to access the Internet. In general, the different wireless router settings are not the same, but the principle of setting is not too much, it may be a wireless router more than one function, it is different settings. The following focuses on the problems encountered in the wireless router setup.

PC and no lines connected by

First of all, of course, connect the wireless router correctly. Before configuring a wireless router, you must connect the PC to the wireless router, and the other end of the network cable to the LAN port of the wireless router, and then connect the modem out of the line to the wireless router's WAN port, so OK. The following figure



Login to the management interface of the wireless router. Enter 192.168 on IE on the PC connected to the wireless router. 1.1, most of the wireless router default management IP is 192.168.1.1, username and password are admin, the specific wireless router can refer to the relevant instructions, instructions on the landing of the wireless router's management interface username and password.

If you enter the 192.168.1.1, you can not open the address, that is, the PC network settings, open the connection properties, IP address set to 192.168.1.x, (x 2 to 255) the other default, the gateway may ignore. or choose to assign IP automatically.



After entering the configuration interface of the wireless router, a setup wizard will automatically pop up. For starters, follow the Setup Wizard next. In fact, the Setup wizard is the same thing as manually setting up your own project.

In the network parameter settings of a wireless router, you must set the parameters for the two interfaces of the LAN port and WAN port. In practice, many users only set the WAN port, and the LAN port setting keeps the wireless router's default state.
The router's WAN port settings:

If the WAN port to the device is the dynamic allocation of IP, that should choose dynamic IP users, but this situation is rarely encountered, the average family is to use the PPPoE mode or static IP mode. To use the wireless router dial-up users, you should select the PPPoE mode, the corresponding ADSL user name and user password. If the fixed IP access to the WAN port, then the static IP user groping, if the following figure.



LAN port settings for routers:



After the LAN port and WAN port configuration is complete, we will configure the wireless parameters below. When configuring a wireless router, there are no strict steps, and the author recommends that users configure them in the order in which they are configured in the wireless Router configuration page.
Wireless configuration:



In the basic settings, when the user does not need a wireless network, you can choose to turn off, this feature is currently not available in many brands. has 14 channels to choose, the general brand is mostly 11~13 channel, here we recommend the use of automatic switching the best channel.

　

Wireless encryption is a must set, in case of forgetting to set the password, it is likely to be stolen broadband, but also may be invaded to the computer, if the encounter is a master hacker, planted some trojans or viruses, it is painful enough. So when you start a wireless network, be sure to modify the wireless encryption. The method of setting a password is very simple, just set a password in the wireless router, and then enter the wireless network card end.



Access control is managed through a MAC address, and is managed with both permission and Prohibition, just like MAC address binding management.



The advanced settings recommend that you select Automatic, such as rate and leading frame types.



The number of wireless connections can be seen in the list of connections, including MAC address, status, frequency band, speed, etc.

The functional interface of the equipment is all Chinese, in addition to the Quick guide and help, as long as the careful reading of the help of the introduction, I believe it is not difficult to set good. When these settings are complete, you can access the Internet by enabling the corresponding wireless network on the PC side.