How to set up a Mercury wireless router

How to set up a Mercury wireless router

Mercury wireless router to cheap and cost-effective into a lot of families, the following for you to introduce the brand router settings.

Connect and log in to the router

Mercury Wireless Router setup The first step: Connect your home Internet Gateway Network cable to the WAN port of your router, and connect your computer to the LAN port of your router with a pre-prepared network cable (as shown below).

Step two: Enter 192.168.1.1 in the browser to access the Mercury Wireless router management interface to set it up.

Tip: Some routers also have an ISP network service provider provided by the fiber-optic cat has occupied an IP address 192.168.1.1. So in order to prevent IP address conflict, the router's IP address will be changed to 192.168.1.2来 management, of course, the initial login management interface router IP initial address is usually 192.168.1.1.

The third step: in the subsequent landing screen, enter the user name: admin, Password: admin.

Tip: The initial user and password set by the Mercury wireless router are admin, and for security reasons the initial password and user can be broken.

Basic setup in the Admin interface

The first step: After the landing screen has been successful, in the subsequent interface, click on the "Setup Wizard".

Second step: On the right side of the wizard prompt screen, click "Next".

The third step: in the next screen, choose your way of surfing, usually everyone's Internet mode is PPPoE virtual dialing method, which is the default mode of the router, and then click Next.