How to Set Up A Router

Set vroThe procedure is as follows:

Step 1: connect the network cable and turn on the power! Start ~ Right-click "Network Neighbor"-"attribute" on the desktop"

In the "Network Connection" window, right-click "Local Connection" and select "properties"

Go to "Local Connection Properties", find "Internet Protocol (TCP/IP)", click "properties" below, and go to "Internet Protocol (TCP/IP) properties window, here we specify an IP address for it, such:

We set the IP address to 192.168.1.188. Of course, you can change the following 188 to 2 ~ If you see any one of 254, A friend asks: The computer prompts an IP conflict. There cannot be two identical IP addresses under the same gateway. That is to say, you can set the IP address to 192.168.1.100 on the server, then, you cannot set the IP address of computer B to 192.168.1.100. On computer B, you can change the IP address to 192.168.1.101! The subnet mask is default: 255.255.255.0 gateway is the IP address of the route. The next DNS server will look at what network you are on. The network is different, and the DNS is different.

If you are not sure about the IP address of your DNS server, you can view it in "details" in "network connection status"-"supported" When dialing a single server! If your DNS is wrong, you may not be able to open the webpage! So when writing DNS, you must know the IP address of your DNS server! If you are not sure what the IP address of your DNS server is, you can choose to automatically get the IP address and automatically get the DNS server address! However, it is possible that IP addresses cannot be obtained on some hosts! Remember!

Okay. Enter the IP address after writing it.Vro, Enter our broadband account and password! Open the "Internet Explorer" Web browser, such:

Open IE, enter the IP address of the router: 192.168.1.1 in the address bar, and press Enter.

In the displayed dialog box, enter the user name and password.

 

To prevent a newbie from making a mistake, this is not your broadband account and password, but the default account and password of your vro. The above noted, the user name and password are admin, if you are not a TP-LINK router, then please refer to your manual, there will be written in.

Go to the router page: different routes. The page displayed here will be different!

Click "Setup Wizard" to set our broadband account and password!

Generally, the home user's broadband network is not included in the ADSL cable modem). Of course, the "ADSL virtual dialing" option is selected.

Then, enter your current bandwidth account and password! You cannot find it? Then I don't know how much you are! This is my account!

Click Finish. The setting is successful! When entering the account and password, be sure not to enter an error. Remember to distinguish between uppercase and lowercase letters and numbers. If the input is incorrect, the dialing will fail! Remember! After, some routers may restart, and some may not. At this point, we need to wait a moment and wait until the vro restarts to get online.

After the vro is automatically restarted, click "running status" to check whether the dial is successful! When we see this interface, we have successfully set up the router!

If you do not automatically restart a vro after it is set up, you need to restart the vro and the cat to make the dial normally after it is set up! You don't need to find the router. If you don't need to press the restart key, you just need to dial the power and plug it in. Is that simple? Have you learned?