How to handle the printer jam

For industry users, basically will be the generation of printers, but the process of using the printer, almost everyone has encountered the problem of paper jam, for the paper jam This problem is relatively headache, we usually can be a simple solution, but the frequent problem of paper jam not only causes waste of resources, But also affect our work efficiency; There are many reasons why the printer is jammed, if the user's paper does not meet the requirements of the printer, the paper is improperly installed and the printer contains confetti, then the appearance of the paper jam is inevitable, so how can we avoid the problem of the printer paper jam, is our each user needs to understand the thing, the following article is aimed at this question for everybody detailed introduction, needs the user to try quickly!

What is the reason for the printer jam?

Paper Jam is one of the most common printing failures in daily printing, with the following three main causes of paper jam:

First, use poor paper or paper damp

If there is no problem checking the printer part, the most likely problem is the paper. Poor paper often attached to a lot of confetti, the printing process of confetti into the machine, thereby causing pressure to rub the paper wheel, increase the possibility of cardboard.

Paper is too light and easy to jam, especially for double-sided printing, paper because after a heating and ink infiltration printing has been distorted, if the weight of the paper is less than 60 grams, it is easy to appear paper jam phenomenon. Paper damp, paper stained with wet, paper jam is also easy to appear.

Second, the software configuration problem

If the software Setup error will also appear paper jam phenomenon, for example, the paper tray into other sizes of paper, but the software settings are still set in the A4 size of the paper, this will occur paper jam. Sometimes it is neither a hardware problem nor a software problem, and there is no paper inside the printer, but the printer still prompts for the paper jam, which can be done to clear the memory operation, and the way to clear the memory operation is very simple. Press "Feed + clean + power" and press "clean" for 10 seconds.

More in exchange for paper rollers

Third, the aging of parts

If a printer to use more than 1.5 years, the spare parts will begin to aging, especially the rubbing paper wheel, the paper roller and the Separation claw wear, which is the main cause of paper jam. If the paper has just entered the machine, it will be jammed. This phenomenon is generally caused by rubbing paper wheel wear and tear so that the printer is not in place, if the wear is not serious, with a wet cloth scrub clean several times. If used for a period of time, there will be a failure. And at this point, you do not want to change the paper wheel, you can try to rub the paper wheel to slightly deal with, the rubbing paper wheel above the leather sleeve, turn down, 180 degrees and then set. Or take off the leather cover to wrap a few laps on the top of the tape and then put on the leather condom, so that its diameter bold, offset its wear. If you use a period of time and then fail again, you will have to replace the pickup wheel to completely resolve the problem.

For a laser printer, the paper roller is also the most easily worn part of the printer. When the paper plate inside the normal, and can not take paper, often is the paper roll wear or spring loose. There is not enough pressure to feed the paper into the machine. Paper roll wear, temporarily can not be replaced, can be wound rubber band method for emergency treatment. After winding the rubber band, the friction of rubbing paper is increased, and the paper can return to normal.