How to install a router for home broadband

During the installation and setup of the home router, we will encounter different problems. Here we will share with you the specific setup steps and introduce the DNS and DHCP settings.

A home Broadband Router is used to connect the main line of the network, such as the line from the cat, to the WAM interface, and other interfaces to the computer or hub. Generally, these routers use IP addresses of 192.168.1.1, and some brands use other IP addresses. You can enter this IP address in the IE address bar to set the router. If the IP address cannot be opened, set your computer IP address to 192.168.XX. Here, XX can be one of the 2 to 254 IP addresses. If you open it, you will need your management username and password. It is generally admin, but I don't know if you change it. If you don't remember it, you can find the reset key on the vro, under power-on, press it for about 30 seconds. In short, the light on the vro is normally lit. It will return to the factory settings. Note: This is dangerous. Improper use will damage the vro.) after entering the vro, you can set up a wizard and follow the prompts. In this case, ADSL is the PPPo method ).

The setting method is as follows:
First, check whether the line connection is correct. the network cable of the broadband (or ADSL Modem) should be inserted at the WAN port of the router, and the network cable of the computer should be inserted at the LAN port of the router. correct line connection, please follow the settings below (TP-LINK TL-R402M router, WinXP system ):
1. Start → Control Panel → double-click "network and dial-up connections" → click Select Local connection corresponding to the NIC connecting to the vro → right-click and select "properties" → on the displayed "general" page select "Internet protocol TCP/IP) "→ press" properties "→ the" Internet protocol TCP/IP) properties "window pops up → select" Use the following IP Address "→ fill in" IP address I) "192.168.1.2, "subnet mask U)" 255.255.255.0, "Default Gateway D)" 192.168.1.1, "DNS server" fill in later → all the way to OK.
2. Open IE browser, on the menu bar, click "Tools"> "Internet Options"> "Connect"> delete all existing settings in "dial-up and virtual private network settings"> click "LAN Settings ". → "LAN" is displayed) set window → check before automatic detection settings, otherwise, do not tick → return all the way to IE → enter 192.168.1.1 in the address bar and press ENTER → enter the vro username and password in the pop-up dialog box as admin by default) → OK, the "setting wizard" pops up, and obtains the DNS server address based on your Internet access method.
3. in step 1, enter the "Internet protocol TCP/IP) properties" window → select "Use the following DNS server address E) "→ fill in the obtained DNS server address after" preferred DNS server "and" Alternative DNS server "→ all the way to OK.
4. Set other computers according to steps 1 and 3 to share bandwidth for Internet access. Note that the "ip address I)" entered in step 1 must be 192.168.1.2 ~ 255, but the two machines cannot be the same.