How to install and use the recorder Software

 

I got up early in the morning and didn't take my cell phone. I called Zhou to print the car program and got stuck in the Word version. This is not enough, aunt asked me what I did at school. I said the competition was good. The question of the recorder started during the day. At first, aunt said that there was a problem with the software, it turns out that it is not easy to use, not especially, but it is very quick to get started and solve software problems! After dinner in the afternoon, I took some gadgets, changed the recorder, and two computers. They were dizzy from!

To sum up, there are two small problems today: 1. For the CD-r disc burning, it means that it cannot be modified after burning, it is not to say that you can only write it once (you have only engraved it once, that is, you have only performed a dial operation once). Theoretically, as long as the disc has space, you can add files to it multiple times, however, the disadvantage is that the data will be burned into a multi-segment disk, that is, the storage of the disc is from the partition segment (it seems like nonsense), and each time the file is appended, at least 22 MB of space is consumed, even if your engraved file is only 1 kb. When using the recording software, be sure to check the option of multi-segment before the last one starts to burn, and then you can set whether to automatically pop up the disk after the option is burned. This is two important tips! 2. About the Jumper settings during the installation of the recorder, after preparing the recorder, you need to change the computer (so difficult, there is static electricity !!), Then, unplug the data cable and power cord of the optical drive, replace it with a burner, and power it on. Why? G: Why is the disk missing? What's going on? Is the line not connected? I initially suspected it was, but I still checked whether there was a problem in the bios, that is, the settings of the Master/Slave disk. A look, wow, there is a problem! No optical drive, Hum. It's basically a jumper problem !! Haha

Then I got my computer down again. Alas, it was a problem. I unloaded the burner and looked at the icon on the back! The jumper is located at the location of the main disk, and the computer has only one ide interface, the hard disk is the main disk, the recorder is naturally from the disk, set the Jumper correctly (there is a small cap, place its position in the proper position according to the instructions on the panel, and you will know it after reading it!

There is a small difference between the Jumper settings of ASUS and pioneer's recorder, but the difference is similar. You can see the panel at a glance!

I still feel that the hardware is quite fun. I have made an extra small salary today.