How to maintain LCD monitor

In the daily enjoyment of the LCD that unusual high-grade display effect at the same time, do not forget to maintain this extremely important link. Only if the LCD is well maintained, it can serve the customers for a long time without fault. It should be clear that the expensive LCD, as long as the following some simple maintenance steps, you can serve a long time.

　　First, avoid the inside of the screen burn

CRT monitor can burn out because of long-term work, for LCD Also, so must pay attention to, if in use, must turn off the monitor, or reduce the display brightness, otherwise long time, will lead to internal burn or aging. This damage, once it happens, is permanent and cannot be undone. In addition, if a fixed content is displayed continuously over a long period of time, it may cause some LCD pixels to overheat, causing internal burn.

　　Second, attention to maintain humidity

General humidity in the 30%~80% monitor can work normally, but once the indoor humidity is higher than 80%, the display inside will produce condensation phenomenon. Its internal power transformers and other coils are also prone to leakage of electricity, and may even cause wiring short circuit, and the high voltage of the display is very easy to produce discharge phenomenon, the machine components are easily rusty, corrosion, serious when the circuit board will short-circuit. Therefore, the LCD monitor must pay attention to moisture-proof, long time does not use the display, you can work on a regular basis for a period of time, so that the display when the heat generated by the machine will be driven out of the moisture.

Also, don't let anything with a damp nature enter the LCD. The mist was found to be lightly wiped with a soft cloth before the power was turned on. If the wet copy has already entered the LCD, the LCD must be placed in a warmer place so that the moisture and organic matter evaporates. With the humidity of the LCD power, can cause the liquid crystal electrode corrosion, resulting in permanent damage.

　　Third, clean the screen surface correctly

If found on the screen surface stains, can be stained with a little water soft cloth gently wipe it off, do not spill water directly on the screen surface, water into the LCD will lead to a short circuit.

　　Iv. avoidance of shocks

The LCD screen is very fragile, so to avoid strong shock and vibration, LCD contains a lot of glass and sensitive electrical components, falling onto the floor or other similar strong hit will cause the LCD screen and other units of damage. Also be careful not to exert pressure on the LCD display surface.

　　V. Do not do it privately

One rule is: Never disassemble an LCD. Even after a long period of shutdown, the CFL converter in the background lighting assembly may still carry about 1000V of high pressure, which can cause serious bodily harm. So never try to disassemble or change the LCD screen to avoid high pressure. Unauthorized repairs and changes can cause the display to temporarily or permanently fail to work.