How to reload the system with CD-ROM and u disk

First, the CD-ROM reload computer system

1, restart the computer, start to hold down the DEL key, enter the BIOS settings, set up the computer to start the CD-ROM drive.

2, the system CD into the CD-ROM drive, restart the computer.

3, follow the prompts to operate, installation system.

4, System installation and then install the motherboard driver, graphics driver, sound card driver, network card driver. This is a fully installed version of the system CD operation method, the proposed direct use of the ghost version of the system CD-ROM, because it is basically a fool installation mode, only need to start the computer to set the CD-ROM drive, put the CD, press the prompts to install.

Two, u disk reload computer

(a) Make good U disk Startup disk.

1. Download MAXDOS+WINPE, first go to the Internet to download a "Old Peaches WinPE" tool to the hard disk, and then the U disk connected to the computer, and then follow the steps of the following step-by-step can be made to start a U disk.

2. Enter "Y" return in the installation interface.

3. The installer will detect the USB disk you are currently connected to and list it. If you do not detect a U disk, please reseat the U disk and press "Y" to return to the main menu and start the installation again.

4. Press any key, pop-up format tool,---selected U disk--FAT32--GA began to format the U disk.

5. After the format is completed, click "OK" and click "Close" below, the installer will enter the next step, write the boot record, press any key to enter the write boot record.

6. Press any key, (1) disk: Choose U disk. (2) Option: Can not make any changes, you can also check four: Do not save the original MBR, not boot the original MBR, output details, start without searching floppy disk. Point [Setup] begins writing boot.

7. After writing the boot record, enter--exit.

8. Press any key to write data.

9. Data writing interface, in the ' Target folder ', click ' Browse ', select U disk, tap [install]

10. After the installation is complete, press any key to exit

11. At this point, the dual-boot U disk Startup disk on the production, restart the computer, in the BIOS set HDD in the USB boot.

12, copy the system CD-ROM image files ISO and ghost image files to the U disk.

(b) Three ways to install the system with U disk:

1 u disk boot, into the PE, start-----Disk disc tool--virtual Drive Manager (PE self-contained virtual CD-ROM)--load--Browse--Select the CD-ROM image file ISO on the U disk,----open-OK. (At this point, Virtual Drive Manager does not close) (At this point, open the PE under the "My Computer", "Removable Storage Device", you have just selected the mirror of the CD. )。 You can then install the system by finding the Ghost program from the Start menu.

2. u disk start, into the PE---start-Program-cloning tools-Call the Ghost interface, select a U disk on the Mirror file Gho, you can install the system to C disk. 3. Load virtual optical drive,--Select the ISO CD-ROM image on U disk,--open the virtual optical drive,---Browse the CD-ROM file,--double-click the Ghost Mirror Installer,-Determine---Restart the computer-after the boot, automatically enter the Ghost interface for installation system.