How to set Tp-link td-w89941n no lines by mode

to set the method of Tp-link td-w89941n without line mode

IPTV Introduction: IPTV is a carrier to provide users through the network to watch TV business, different from network television, the corresponding service providers need to open the business side can be viewed.

Step One: td-w89941n installation

1, network cable households: The network cable inserted in the td-w89941n LAN 4/wan interface, in the preparation of a network cable, one connected to the computer, the other end of the connection td-w89941n LAN1 interface, as shown in the following figure:

2, Optical brazing: Please prepare 2 short cable, one to connect the light cat and td-w89941n Lan4/wan interface; Another network cable, to connect the td-w89941n LAN1 interface and computer, the connection mode as shown in the following image:

Step two: Set the computer IP address

When setting up a td-w89941n routing machine, you need to set the IP address of the computer to be automatically obtained, as shown in the following figure.

Step three: Set up td-w89941n machine

1, Login Settings interface: In the browser's address bar input: tplogin.cn and press the Enter button--> "Set password" after filling in a login password--> "Confirm password" again enter the previous set of password--> click "Confirm".

Warm tip: Only in the first time to login td-w89941n integrated machine settings interface, will require users to set the login password, then log in, then require the user to enter the previous set of login password, otherwise it is unable to log in.

2, select access mode: After entering the Setup interface, click the "Setup Wizard"--> select "Community Broadband LAN Access (Network): The device set to wireless routing mode"--> click "Next".

3, choose the way of Surfing the Internet: select "PPPoE (ADSL virtual dial)"--> click "Next".

4, "User name" fill in your: Broadband user name--> "password" fill in your: Broadband password--> "Confirm password" again enter your broadband password--> click "Next".

5, set up wireless network: "Wireless network Name": User-defined Settings--> "encryption Mode" SELECT:wpa-psk/wpa2-psk--> set "Password"--> click "Next".

6, check "Enable IPTV function"--> select "ITV"--> click Next.

Warm tips

(1), if you need to use wireless to watch IPTV, check the use of a wireless network as a IPTV port, and set the corresponding wireless parameters.

(2), such as local IPTV line requirements set VLAN tag, then tick the set VLAN tag, and fill in the corresponding tag value.

7, check the "parameter summary" below the data, confirm the correct click "Next".

8, click "Finish".

Note the problem: In some cases, you may be prompted to reboot, follow the instructions.

Step four: Detect if the settings were successful

In the td-w89941n set the interface click "Home", view "Internet connection", if the "Connection status" show connected, and "IP Address" and "DNS server" after the IP address, the description of the successful setting, can be normal Internet.

If the connection status shows: Not connected, indicates that the setting is unsuccessful, the user needs to follow the installation and setup steps described above to carefully check and troubleshoot errors.