How to set the Tp-link wr702n Wireless router AP Mode

tp-link wr702n Wireless Router AP Mode Setting method

Step one, set up the computer IP address

Before setting up the tl-wr702n router, you need to set the IP address of the computer to be automatically obtained, which refers to the IP address of the wireless network card on the notebook computer. (PS: If not set, please click to read: computer automatically obtain IP address settings method)

Computer set to automatically obtain IP address

Step two, wireless connect to the TL-WR702N router wireless network

The computer searches for and connects to the TL-WR702N router's signal (the router default SSID is: tp-link_xxxxxx (six digits behind the MAC address) to view the MAC address on the router's bottom sticker.

A wireless network connected to a TL-WR702N computer

Step three, log on to the TL-WR702N router Setup interface

1, open the computer desktop Internet Explorer, empty the address bar and input: 192.168.1.253 (admin address), enter the page will be pop-up login box (ps:192.168.1.253 can not open?) please click to read: 192.168.1.253 open Solution

Enter 192.168.1.253 in Browser

2, in the Login password box, enter the router default management password: admin, click Login, enter the management interface.

Enter Password login for tl-wr702n

Step four: tl-wr702n AP Mode settings

1, Run the Setup wizard: Enter the router's management interface, click the "Setup Wizard"--> click "Next".

The Setup Wizard for the tl-wr702n router

2, select the mode of work: Here you need to select "AP: Access point mode"--> click "Next".

Select "AP: Access point mode" on the tl-wr702n router

3, wireless network settings: Wireless network settings: "SSID" that is, the wireless network name, users according to their own needs to set--> tick "WPA-PSK/WPA2-PSK"--> set "PSK password"--> click "Next".

Set up a wireless network on the TL-WR702N Mini wireless router

Warm tip: "SSID" do not use Chinese and special characters; PSK password "Please use capital letters, lowercase letters, number of combinations set, the length of more than 8 bits."

4, restart the router: click "Reboot"--> will pop up the restart Prompt dialog box, click "OK" again.

Reboot after TL-WR702N setup is complete

Step five: Connecting lines and surfing the internet

Connect the network cable to the TL-WR702N wireless router's Lan/wan interface as shown in the following illustration:

The original network cable to connect to the TL-WR702N Lan/wan interface, thus completing the Tp-link tl-wr702n Mini wireless router in AP mode settings;