How to set up a router to connect to a wireless router

First, you need to prepare two routers, one of which is the wireless router. Here we use the Tp-link.

Methods Show:

Prepare before setting: If you have previously changed the router's settings, it is best to revert to the router's "factory settings" first.

First, you need to prepare two routers, one of which is the wireless router. Here we use the Tp-link.

1, after restoring the wireless router tp-link_r860, insert the broadband plug into the tp-link_r860 Wan port. As shown in the figure:

2. Then connect the cable to one end of the cable router any LAN port, the other side connected to the computer network port, (the network is set to automatically obtain the IP address) and then connected to the cable router power, waiting for 10 seconds or so, to all the lights from the start.

3. Landing http://192.168.1.1, login username and password to admin interface.

4. After landing, through the left of the "Setup Wizard" to complete the router's Internet settings, and restart the router. Then access the router to see if the Internet can be normal.

5. Enter the router management interface again, enter the admin account and password to find the "LAN settings" in the left side of the page, change the LAN setting of "IP Address" as "192.168.10.1" in the figure to "save" and restart the router.

Note: A carefully look at the label on the back of the router, "Default settings ip:192.168.1.1" Management IP address, if the same two routers must change one, two default addresses can not be the same, no one can not normal Internet access. B in the future use, if you restart the router, re-enter the management interface, your landing site must be the site you have changed to "192.168.10.1." Do a good job of marking.

6. Now, connect the wired router to the wireless router, one end of which is plugged into any interface in the LAN interface of the tp-link_r860[wired router.

7. Then, use a wired network cable to connect one port on the LAN port of the wireless router, and the other end is on the computer net port. Power on and wait 10 seconds.

8. Then enter the "http://192.168.1.1", login to the wireless router management interface, with the "Setup Wizard" for further setup:

9. Choice of Internet mode: "Dynamic IP". If it is "fixed IP", directly enter your IP on the watch.

10. In the wireless settings, set the name of the wireless router SSID and password

11. Finally, Setup completes, click "Finish" and restart the wireless router. Test whether the network is able to access the Internet properly.

Tip: If you do not have a normal Internet connection, please reset it again in this way.