The setting of a wireless router network is quite confusing for new users. This article will provide you with a simple step. Generally, the wireless router settings are the same. I believe that after reading this article, this gives you a clear idea about how to set up a Wireless Router Network.
◆ How to set Wireless Router Network Part Of The DI-524M as an example)
When your computer is connected to a router, set the Wireless Router Network on the DI-524M as follows:
After connecting to the DI-524M, open IE, type 192.168.0.1 in the address bar, and press Enter. Enter the vro user name and password To Go To The vro configuration page.
Click Wireless settings on the left. By default, the DI-524M wireless feature is active, that is, after you turn on the router, your computer can find the device through the wireless network card); the default wireless network name SSID) is the name of the device that can be searched for by dlink); the default channel is 6; no security mode by default.
"Activate wireless" can enable or disable the wireless function of the router.
The "wireless network name" is the name of the wireless network that the computer can find. Some routers are also called "SSID"
"Wireless channel" can be selected manually, or the "Automatic channel scanning function" of the router can be used ".
We recommend that you use the "auto-scan channel function" to avoid frequency interference from other wireless networks.
◆ Encryption is also an important step in setting up a Wireless Router Network
You can choose from the following security options: WEP, WPA-Personal, WPA2, WPA2-Auto. Generally, you can choose WEP or WPA-Personal.
The following describes how to configure the encryption mode one by one.
1. WEP Encryption
After selecting WEP Security mode, the following interface is displayed.
There are two options for WEP encryption: 64Bit and 128Bit.
There are two password Methods: HEX hexadecimal) and ASCII.
In 64-bit encryption, the HEX password must be filled with 10 hexadecimal characters, that is, the number 0 ~ 9, Letter ~ F or ~ (F). The ASCII code must contain 5 ASCII characters in hexadecimal notation ). The password can be 1 ~ Enter either of the four WEP passwords. Click "Save settings ". After the router is automatically re-activated, the configuration is complete.
2. WPA-Personal mode
For the above two methods, you only need to enter a shared password, and then click Save settings above.
Basically, the configuration of the Wireless Router Network is complete. Different routers may be different, but generally the steps are the same. For details, refer to the user manual.