Based on different home broadband lines, three access modes are available: network cable, telephone line, and optical fiber.
Router Mode shared bandwidth circuit diagram
1
, Adjust the router mode switch
Adjust the mode switch on the vro
ROUTER
Mode, As shown in the following figure:
2
, Set computer wireless network card parameters
Before setting a vro, you must set the wireless network card of the operating computer to dynamically obtain the IP address. If you do not know how to set it, refer:
Search for the wireless signal of the router and connect it. The default SSID of the vro is:
TP-LINK_XXXXXX(
XThe last six digits of the MAC address identified at the bottom of the vro ). If you do not know how to connect to the wireless signal, select the operating system of your computer on the following icon and follow the instructions.
1
, Enter the management address
Open ie on the desktop, clear the address bar, and enter
192.168.1.253 (management address). After you press enter, the logon box is displayed.
2
, Logon Management Interface
Enter the user name and password (both admin by default) at the corresponding location, and click
OK. Change the user name and password in time.
System Tools
>
Change logon passwordIt is not recommended to use the default or simple combination.
If you cannot log on to the management page after entering the management address, click to reference:
1
Start setting Wizard
Go to the vro management page and click
Setup Wizard, Click
Next Step.
2
, Select the Internet access method
If you use the bandwidth account and password allocated by the carrier for PPPoE dial-up Internet access, follow the instructions in the article to continue setting. For other internet access methods, select and refer to the corresponding setting process:
If you do not know how to access the Internet, click here:
Internet access method selection
PPPoE(ADSLVirtual dialing), ClickNext Step.
3
Enter the bandwidth account and password
Fill in the corresponding setting box with the broadband Internet account and password provided by the broadband carrier, and confirm that the account and password are entered correctly.
4
Set wireless parameters
Modify
SSID(That is, the wireless network name), in
PSK
PasswordSet the wireless password, click
Next Step.
5
, Set, restart the route
Click
Complete. A dialog box is displayed, prompting you to restart. Click
OK.
Connect the computer to the modified wireless network (zhangsan ). Go to the vro management page and click
Running status, View
WANPort statusIf the IP address is not 0.0.0.0, the setting is successful.
Now, the vro has been set up and the computer can access the Internet.
IfWANPort status The IP address in is 0.0.0.0, http://www.111cn.net/router/tplink/61826.htm
If
WANPort status The IP address is normal, but the computer cannot access the Internet, http://www.111cn.net/router/tplink/61827.htm