How to set up the Puling tl-wr941n 450M wireless Router

tl-wr941n 450M Wireless Router setup diagram Step one: tl-wr941n router installation

1, telephone line users: Please prepare 2 short network cable, a network cable used to connect ADSL modem or light cat on the network cable interface and TL-WR941N router on the WAN interface, another network cable, one connected to the computer, the other end of the tl-wr941n router to connect the 1/2/3 any interface.

2, Optical brazing users: users need to prepare 2 network cable, one of the network cable used to connect the light cat and Tp-link tl-wr941n Router WAN interface, another network cable to connect the computer and Tp-link tl-wr941n Router LAN interface (1/2/3/ Any one of the 4 is OK).

3. NET Network: Please prepare 1 short network cable, network cable households: refers to the broadband operators to provide a network cable to the user's home; Please first plug the network cable provided by the broadband operator into the WAN interface on the Tp-link tl-wr941n router, and then connect the prepared network cable to the computer, The other end connects the 1/2/3 arbitrary interface on the Tp-link tl-wr941n router.

Note The problem: The LAN status LEDs for the LAN port on the TL-WR941N router panel and the network card LEDs on the computer must be lit.

Puling tl-wr941n 450M Wireless Router Setup diagram Step two: Set Up computer IP

When connecting the tl-wr941n router to the Internet, you need to configure the IP address of the computer to be a dynamic IP address (automatically acquired); Because the router has DHCP service enabled, you can assign computers the IP, gateway, subnet mask, DNS, and other addresses needed to access the Internet.

Puling tl-wr941n 450M Wireless Router Setup diagram Step three: Set up the tl-wr941n router

1, Login Management interface: Open a computer on any browser, in the browser's address bar input: 192.168.1.1 and press ENTER (enter)--> in the pop-up dialog box enter the default username: admin; default login password:admin--> click " Ok. "

2, Run the Setup wizard: the initial configuration of the tl-wr941n router, the system will automatically run the Setup Wizard, if it does not eject the page, you can click on the left side of the Page Settings Wizard menu to activate it.

3, choose the way of Surfing the Internet: select "PPPoE (ADSL virtual dialing)"--> "Next".

4, configure the Internet account: Please according to the ISP broadband operators to provide broadband username and password, fill in the "Internet account", "Internet password"--> "Next".

5, wireless network settings: "Wireless Status" selection: Open--> Set "SSID", the SSID is the name of the wireless network, note that the SSID can not use the Chinese--> select "Wpa-psk/wpa2-psk"--> settings "PSK password"--> " Next. " PS: "Channel", "mode", "band bandwidth" and other parameters remain the default, no configuration.

6, click "Reboot".

When the router restarts, we complete the installation and Internet setting of the Tp-link tl-wr941n 450M wireless router, at which point the computer connected to the TL-WR941N router can go directly to the Internet, and the computer does not need to dial the connection again. Wireless terminals such as smartphones and tablets can also be connected to the TL-WR941N router's wireless internet.